NordicTrack C900 Pro Won't turn on

Question edited for clarity and typos.
Question moved from Televisions Category, to make model.

It is either that the belt is too tight, or the belt is worn out. The rollers are slightly 'crowned' fatter in the centre than the edges. If the belt is too tight, it will pull the edges up, or it is has been run too long or too tight, the belt wears in the centre, so being thinner in the centre, it curls. Time for a new belt.

Posting pictures is easy. :>D

Apparently the key is magnetic, so perhaps you had a magnetic event? Having said that, it shouldn't run unless switched on. Better to turn off at the mains when not in use.

https://www.google.com/search?q=nordictrack+a2550+pro+started+without+key

..

Hi There,
I repair these machines in Australia for the distributor .
it may need a LCB or a motor.

If you're seeing the WiFi but cant connect to it try using a different type of security like WEP OR WPA.

If you cant see the WiFi at all try to use a range extender. The treadmill might be too far away from the router.

pleaso go to http://support.nordictrack.com/

and download PDF.

God bless you

You probably pinched some wiring during assembly. Could be the controller but more likely the wiring.

Check the power cord to ensure it is connected to the power supply and the treadmill if the power does not stay on or does not turn on. Look at the circuit breaker, located near the base of the unit, to see if the circuit was tripped. Push the switch back in to reset the circuit.

2 Take the key out of the console, wait a minute and place it back in the console to resolve issues with the power turning on and off during use or if the console displays are not functioning properly.

3 Remove the console key and press the "Stop" button to turn off the "Demo" mode, which is often the default setting when the treadmill is first purchased.

4 Reset the incline by holding down the "Stop" and "Speed increase" buttons and putting in the console key. Release the buttons and then press the "Stop" button, followed by the down or up arrows for the incline. This step can be taken if errors are occurring with the incline function.

5 Turn the treadmill "Off" and unplug the unit if errors continue. Wait five minutes and then plug the unit back on, insert the console key, and turn the treadmill "On." This will reset the treadmill and should return to normal funcTION

Manual with troubleshooting guide
https://www.sportsmith.net/images/product_support%5CNordicTrack%5CNTL10850%20-%20NORDICTRACK%20A2050%20TREADMILL%5CNTL1085.0-214878.pdf

https://www.justanswer.com/fitness-equipment/3tp0k-nordictrack-a2050-treadmill-just-recently-won-t.html


https://www.youtube.com/watch?v=Lx9zhfXok2A
https://www.sportsmith.net/images/product_support%5CNordicTrack%5CNTL10850%20-%20NORDICTRACK%20A2050%20TREADMILL%5CNTL1085.0-214878.pdf

I just had the same problem. Of course tech support is closed so I sent an email. We'll see if they get it fixed tomorrow.

The Co6 code not exist.C60 code is the driver scanner malfunction.