Question about Metra Ford F 150 Truck 1996 Up

1 Answer

No tail instrument dome or 3rd brake light 2000 f-150 good bulbs good fuses?

Posted by jaybizz_76 on

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points
    MVP:

    An expert that got 5 achievements.
    Vice President:

    An expert whose answer got voted for 100 times.
    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 400 Answers

Get a continuity checker for 10 dollars and check the ground on the light where it touches the body the light might not have sufficent gound. for the light to light. ( basic electrical knowledge)

Posted on Jul 08, 2009

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 Pontiac Vibe no tail lights, brake lights and turn signals work just fine. The dimmer switch does not dim the dash lights but does work the dome just fineand the lights for the Heat/AC are off.
The tail lights work off the headlight switch, and there is a fuse for the tail lights. Make sure the fuse is good, first, a 15 amp (blue) fuse in the instrument panel fuse block. Then, you might have a bad headlight switch.
So you DO have dash lights, they just don't dim from the dimmer switch? In the wiring diagram, there is a green wire from a "tail light relay" (in the "Junction Block-Right Instrument Panel") that carries power to all the exterior lamps, as well as having a splice to the Instrument Panel Cluster (illum. bulbs), and to the lamp dimmer, and to the radio bulb.
To do any further testing, you would need a voltmeter or a test light, so you could chase down this power loss. Good luck.

Oct 17, 2016 | 2003 Pontiac Vibe

1 Answer

I recently replaced the front rotors, brake pads and master cylinder in my 2003 Durango. I've since discovered that the brake lights are not working, including the 3rd brake light in the tailgate. I...
Hello, Well there is not much more it could be unless you have a shorted wire or a burned fuse. I would normally think that the turn signal canceler was bad but the 3rd brake light will still work if that is bad so I would check all fuses and for bare or shorted wires.

Jan 18, 2011 | 2003 Dodge Durango

1 Answer

Tail lights and instrument lights not working. headlights and turn signals work. brake lights work. fuse relay problem? If so where is it?
first test your fuses if isnt fuse see if bulbs are bad on tail lights if bulbs are good do you have a dimmer switch for your dash see if you have it on

Dec 10, 2010 | 2003 Kia Spectra

2 Answers

Brake lights in the each tail light not working. Both bulbs are good, and 3rd brake light works. Can it be a blown fuse, if so which fuse. It's a 2004 dodge durango 5.7 hemi
it could be a bad ground in the tail lights

Sep 26, 2010 | 2004 Dodge Durango

2 Answers

'99 Expedition brake lights aren't turning on when pressing brake
It could be a number of things, the good news is that none of them are serious or expensive to fix.

The normal components that make up your brake circut are:

1. The brake light fuse (In the fuse box and labeled as such)
2. The brake light switch/relay - also called a stop light switch. It's under the dash, right behind the brake pedal arm. When you push the brake, it sends a signal to the lights which turns them on. Think of the dome light switch in the door jam of your truck. When you open the door, it releases the switch and your dome light pops on. Same thing with the brake light switch.
3. The bulbs in the tail lights and the 3rd brake light.
If none of them are working, it's most likely a fuse or the switch/relay under the dash. If it's the switch, it's a $12 part. Obviously fuses are only a couple bucks.

Jan 18, 2010 | 1999 Ford Expedition

2 Answers

BRAKE AND TAIL LIGHTS DON'T WORK. HAVE REPLACED BRAKE SWITCH AND LIGHT SWITCH. NO CHANGE. LIGHTS ARE GOOD, CAN HOT WIRE AND RUNNING LIGHTS WORK. ALSO WHEN HOT WIRED DASH LIGHTS COME ON
Hi.

Test with a voltmeter the contacts to the fuses for tail lights and brake lights. If there is no power getting to fuses from instrument panel, and switches had already been replaced, then it is a wiring problem from switch to fuse box, otherwise from fuse box to lights. the defective wiring must be repaired or rebuilt.
Regards.

Oct 30, 2009 | Jeep Wrangler Cars & Trucks

1 Answer

I don't have Tail Lights (Red) nor front running lights (Amber), Instrument Panel lights, including the dimmer switch, and liscense plate and back-up lights. However, I do have Brake Lights, Turn...
Hi there, have you tried the radio fuse and lighter fuse as when tail lights and dash lights wont work it is normally one of those.

Jul 26, 2009 | 1996 Isuzu Rodeo

1 Answer

1997 monte carlo. 3rd brake light works, but tail lamp brake lights do not.
The 3rd brake light working does reveal that the fuse is good, and the brake switch is good. Check the bulbs, sockets, and the wiring between the brake lights

Jul 04, 2009 | 1997 Chevrolet Monte Carlo

1 Answer

Brake lights dont work untill i turn the lights on, then stay on
Hi, are the tail lights and the brake lights in the same light unit?
If so, there is a possibility the bulbs are in the wrong way. If it is a stop/tail bulb then there are two locating pegs on the side of the metal part. If you look, one is higher than the other which has to locate into the correct slot in the holder.

Another possibility is the bulb is wrong, there are double and single contacts. Check the contact on the base of the bulb is the same as the contacts in the holder.

TL

Feb 09, 2009 | 1999 GMC Yukon

1 Answer

Brake lights do not work (3rd brakelight does) changed bulbs checked fuse
Problem could be the Brake Light Control Module. That's about the only other thing other than a bad wire somewhere if the bulbs and fuses are good. 91 Accord has 2. One on each side in the smaller of the 2 rear tail light lenses. In order to change the module you have to remove the smaller of the rear tail lights. Drivers side is 5 pin. Passenger side is 6 pin.

Jul 20, 2008 | 1991 Honda Accord

Not finding what you are looking for?

View Most Popular

Ford F 150 Truck 1996 Up

  • Car Audio & Video

Related Question

2003 Pontiac Vibe no tail lights, brake lights and turn signals work just fine. The dimmer switch does not dim the dash lights but does work the dome just fineand the lights for the Heat/AC are off.

  • 2003 Pontiac Vibe

Open Questions:

0 Answers

96 5.8 distributor plugin diagram where you plug the distributor in there are 8 color coded wires and i need to know which ones go to what cylinder

Jan 21, 2012 | Metra Ford F 150 Truck 1996 Up

Related Topics

Metra Ford F 150 Truck 1996 Up Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

1 Answer
Need Toyota wiring diagram for Radio Model 86120-04090

Metra Toyota Lead To Oem Radio...

2 Answers
Where is pacifica factory amp located

Metra CHTO-02 Chrysler Pacifica...

1 Answer
Front door speakers in my 2007 chevy silverado classic dont work

Metra Chevy Truck 88 94

1 Answer
Wiring diagram for gmos 04

Metra Vt Gmos 04 Gm Class II...

2 Answers
94' plymouth voyager care stereo wiring diagram needed

Metra Chrysler/Dodge/Plymouth...

Top Metra Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5023 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

jdthefixer

Level 3 Expert

747 Answers

Are you a Metra Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...