My Sherwood rx 4109 has no sound what do I do

SOURCE: need remote code for sherwood

Comcast came and the receiver / tv was not capable of being run by another remote as far as volume, just off and on

SOURCE: sherwood rx-4109 power shuts off

The output transformers may-be gone
looking at +$50 AUS
for just the parts
or a licensed service
for about $150 AUS

SOURCE: trying to program my At&t Uverse remote to my

Sherwood Receiver/Amplifier 5027 Sherwood Receiver/Amplifier 5027

always press the mode key of the device they want to control before pressing any other key

Power on the device

1. Press and hold the appropriate Mode key (TV, DVD or AUX) on the remote control.
2. Without releasing the chosen Mode key, press and hold the OK key simultaneously.
3. Release both the Mode key and the OK key at the same time.
   All the Mode keys should flash twice.

• If it does not turn off, repeat steps 2 through 6 trying each code for the brand until the correct code is found.

1. Repeat steps 1 through 7 to program other devices if needed.
2. Press the appropriate Mode key on the remote control to work with the selected device. To use the remote control for the Member's U-verse TV Receiver again, have them press the AT&T Mode key.

SOURCE: keeps turning itself off

If Both speakers are working at a low volume and you turn it up and it clips and shuts off you have one of 3 problems. you have over driven your speakers and one has shorted the voice coil but still will work at low volume, its a overload protection for ohms short in receiver. unhook each speaker and turn balance to the one hooked up and turn up receiver if it shuts off do the same with other speaker to determine which side is bad. 2 speaker wires are touching at speaker or receiver. 3 a bad receiver output transister. Good luck.

SOURCE: I need a code to

Hello! Try the link below this should help:
http://www.dishnetwork.com/downloads/pdf/user_guides_and_manuals/Remote_Codes_Web_Page.pdf


Daniel Busa
DISH Network Customer Service