Servis washing machine gets stuck during the washing cycle, it does not matter which programme it is on

Could be several reasons:
- Selected the "Night cycle" program (means standing with the drum full of water, reason: too much noise in the spin cycle)
- Set to the "Rinse hold" (means standing with the drum full of water, reason: wrinkles on the clothes)

According to your description I think that this is not a failure otherwise error E20 will be appears on display.

Once the washing programme has come to an end, END illuminates on the programme progress display.
If RINSE HOLD was selected, the display beside the START/ PAUSE button flashes.
1. After a rinse hold, the water must first be pumped out:
- Either press the START/PAUSE button (the water is pumped out and the washing is spun according to the completed programme;
After the START/PAUSE button is pressed again, the spin speed can still also be changed during spinning), or
- Turn the programme selector to PUMP OUT and press the START/PAUSE button (the water is pumped out without spinning),or
- Turn the programme selector to SPIN or SHORT SPIN and press theSTART/PAUSE button (the water is pumped out and the washing is spun or gently spun).
At the end of this programme step, the END indicator will illuminate.
2. Open the door.
As soon as the DOOR indicator lights up green, the door can be opened.

Dado

replace main circuit board. likely fried.

Un-plug the machine from AC mains wall socket, and re-plug it back after an hour; or so. If you do this over-night will be better. The internal electronic control circuit will reset itself.
http://electronicshelponline.blogspot.com/

Hi from retired Englishman in SW France,

Sorry but this forum does not supply any type of manual or schematic diagram direct; it's just made up of ordinary guys and gals, probably at home and from all over the world, with experience of addressing problems and giving guidance for free on the web ;-0)

You will need to type into your search engine/web browser '(make) washer manual' and you should be presented with a number of sources from which you can either download for free or have to pay a nominal amount. During the process you will be asked for the actual model number!

Good luck,
John C.

I would take the top off and locate the operating lever for the fabric valve as it sometimes gets stuck with soap goo
eric

The burning smell is coming from motor. Also your clutch is bad where you are hearing the rattle/grinding.

the draw of softener need to fill with water "untill certain level" at only last rinse cycle >
so you need to check the pressur of inlet water and the inlet filter it may be clogged
thanks

Hi,
I`ve just spoken with Bosch Product Advice service about this problem. This could be happen when door is open after programme has been started. I didn`t check yet is working.
Thanks, roman

Most likely a defective door switch.

i am having the same problem with my widl126 washer.
ant help?