My radio shack 200 channel scanner is stuck on one channel, it will not scan, I can change channels manually but the scan does not work...I tried turning it off and holding down the 2 and 9 and turning it back on to just clear it but that didn't even work...any suggestions?

SOURCE: 1000 scanner radio shack

press the manual button a few times, and make sure there are actually some freq. programmed into the unit. if there are freq other than 000.000000 in there, press the s/s (lockout) button and see if this unlocks the frequencies to allow them to be scanned.

SOURCE: Radio Shack Pro-95 handheld scanner issues

Here is the online programming tutorial:
http://support.radioshack.com/support_tutorials/communications/200-0523/67345.htm

Here is the full manual Should include Quick guide:
http://support.radioshack.com/manuals/ome20-525.pdf

Here is FREE programming software for the PC:
Includes hardware info. You can buy programming cable at Radio Shack to connect to your PC.
http://www.starrsoft.com/freeware/win95/default.asp

SOURCE: I have a radio shack pro 94 scanner that gets

Getting "stuck" indicates that the scanner may need to be reset to restore proper operation. This is a fairly drastic step that will erase ALL information that you've programmed into the scanner, but it's about the only fix. To reset the PRO-94:

- Turn the scanner OFF

- While holding down the 2 and 9 keys, power the scanner ON.

- CLEAR will flash for about 5 seconds as the scanners clears its memory and restores factory settings. Do not turn the scanner OFF or press any keys until the CLEAR message stops flashing.

Need the manual for your scanner? You can download/print it here:

http://support.radioshack.com/support_electronics/doc61/61426.pdf

Bill B

SOURCE: clearing out old channels on a radio shack pro 95 scanner

Turn it on, and when "Welcome" appears, press zero, then press one. It will display a message indicating it is initializing to the factory state.

SOURCE: i am scanning and can't

Hi my name is John. Turn the unit on, press PGM,enter the channel you want to store the frequency in (1-200), press PGM,use the number keys and DELAY/. to enter the frequency you want, including the decimal point. Press ENTER to store the frequency, and your done..Get your frequency,s here www.RadipReference.com ..or www.RadioFreq.com.. Hope this was helpful.....Rate this solution on the four thumbs-up....good luck.. John