Question about Rock & Ice Climbing

Open Question

The epic drawer that I ordered with my futon did not come with directions on how to put it together. Do you have a manual on how to assemble the drawers that fit under the futon?

No directions came with the drawers

Posted by Ann Geoghegan on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: Removing the refrigerator drawers from the Electrolux side-by-side refrigerator

Got it. My mother got one of these fridges and was frustrated with the drawers not sliding off to clean. It is designed to dissamble the complete drawer assembly. Start by removing the glass from the top of the chill zone drawer frame. Next grasp the white piece of plastic that the chill zone is written on and pull up. There are 4 pegs which affix the drawer assembly to the fridge. The front two pegs will pop out and then the rear will easily pull. The top drawer assembly must be removed before the bottom two drawer assemblies can be removed.

I also noticed the plastic pieces and tried to pinch them but I couldn't get them to budge. Once I saw the 4 pegs, it made sense.

Posted on Oct 25, 2008

Ad

Anonymous

  • 6 Answers

SOURCE: bottom drawer sliding problem

Fisher Paykel sells an improved, black colored set of lit lifting assemblies, better than the white ones installed. If the lid does not clear when you cycle the empty drawer (12 minutes), then you need to order and install all four lifting/sealing assemblies and change them out. With both drawers removed, you can see the four plastic assemblies, two on each side of the empty dishwasher housing.

Posted on Mar 03, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: Frigidaire gltf2940e front loading washer - dispenser drawer magnet replacement

When you are looking at the drawer, the magnet stands upright on the far right side just inside the outer front casing about halfway down. There is a small plastic clip that holds it in place. You don't need to take anything apart to reinsert the magnet, just open the drawer, but it may be easier to see the location if you pull the drawer all the way out of the hole.

Posted on May 16, 2009

Maytag317

Victor

  • 1136 Answers

SOURCE: ice under freezer drawer

Hi, Check in the back rear of the freezer and se if you have ice built up. MOST cases the defrost drain gets plugged behind the rear freezer wall under the evaporator.
Please let me know if I can assist you further.

Thanks
Vic

Posted on May 26, 2009

Anonymous

  • 1 Answer

SOURCE: water standing under crisper drawers

small drain hole/tube inside (behind crisper pans) is stopped up. Clean out with flexible wire, etc.

Posted on Jun 24, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I put my bed together, there was no instruction manual?


Yaletown Black Queen 6-drawer Platform Storage Bed Manual

www.fixya.com > Prepac > Beds > Prepac Yaletown Black Queen...
Owners Manual & User Guide forPrepac Yaletown Black Queen 6-drawer Platform Storage Bed - Bed%20frame%2013302541%20Assembly%20Guide.pdf ...

Yaletown Black Queen 6-drawer Platform Storage Bed ...

www.fixya.com/.../p9574513-prepac_yaletown_black_queen_6_drawer...
Recent Prepac Yaletown Black Queen 6-drawer Platform Storage Bed questions, problems & answers. ... Assembly instructions for the Acme canopy bed.

Nov 19, 2015 | Prepac Yaletown Black Queen 6-drawer...

1 Answer

How do I get assembly instructions for Wildon Home Corvallis Trimline Full Size Futon Frame?


You can contact factory direct or place you purchased from. Contact Us: 877-WAYFAIR (877-929-3247). I know the item is from Vietnam and instructions are not the best.i would lay out all your screws by size. Connect your back board to both end pieces withe the medium size screws. Then mount front board with long screws should be 4 for each side. Then assemble the couch lay down parts place on your assembled base. Uses washers on the long screws as this section swivels up and down. This reduces friction between the wooden parts. I hope this helps. Send your photos to mddoc13atyahhoodotcom. I will try to quite you. Attention Bob

Feb 01, 2015 | Wildon Home Corvallis Trimline Futon Frame...

1 Answer

Victoryland Black Metal Futon Frame assembly instructions


You should contact the store you bought the futon frame from and ask them to send you the assembly instructions or to give you the contact information of Victory Land.

Aug 24, 2012 | VICTORY LAND Shopko Victoryland Black...

1 Answer

How do I clean my futon cover?


In order to properly clean your futon cover I suggest reading the directions sewn into the label by the manufacturer. Most covers can be cleaned by using one of the following methods: spot cleaning, washing machine and dry cleaning.

Aug 01, 2012 | Furniture

1 Answer

Assembly instructions for a Cottonwood Provo Queen futon frame


I suggest that you contact Cuttonwood directly at 1-800-608-7507. You can also contact them through the website at: http://www.cottonwoodfutons.com/info/contact/

Jul 21, 2012 | Furniture

1 Answer

Need assembly instructions and bolt sizes for a twin over futon bunk bed


Can you find out the make of the beds?
If you can look it up on the internet and order the correct sized bolts.
IKEA is easy.
kolbrun

Feb 14, 2012 | Baby Gear

1 Answer

I recently bought a futon but for some reason if you fold it out into a bed and lay in the middle the futon folds up. I think it jsut isnt assembled correctly. Is there a manual to check for the Dorel...


I had the same problem, went to you tube and this guy has a wooden armed one very similar. I was happy that it shows step by step. Just type in assembly instruction futon, and it will come right up. Mind you, the parts are not exact but it was very helpful.

Jul 01, 2010 | Toys

2 Answers

Black futon


Here's what I did for that model. I Googled Dorel Futons. I found the one which resembled mine the closest, and mouse clicked on it. I got "Vermont Style Metal Arm Futon" which is model # 3123098W, and under the Description paragraph, found a link to Instructions. Clicking on that brought me to step by step assembly of the frame, which is just like the F1400BLKS, which is not listed if you enter that model # on Dorel website. Hope this helps!

Sep 25, 2009 | Dorel Alexander

Not finding what you are looking for?
Rock & Ice Climbing Logo

Related Topics:

782 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rock & Ice Climbing Experts

ray gallant

Level 3 Expert

71004 Answers

john h

Level 3 Expert

23515 Answers

rhodesworks

Level 3 Expert

3157 Answers

Are you a Rock and Ice Climbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...