I dropped my phone in water. It stayed in for no more then 10 seconds. Now when I try to charge it, a green light in the upper left corner came on . So I unplugged it and reconnected the charger. No l

It means your battery is fully charged.

the green light are usually a notification of new emails, miss calls things you missed

The flashing Orange light means the charge is flashing.
The flashing Green light means the focus and exposure are not correct.

Have you recently replaced the batteries? Or are you using rechargeable batteries? Lack of enough "Juice" could allow for the flash to not charge up (Orange) therefore not allowing the camera to get the correct exposure (Green). I would try new fresh batteries or a new battery pack. If that doesn't fix the issue it must be a bad circuitry in the body that is shorting not letting the flash charge.

Regards,
Jacob

Make sure that the kindle is fully charged. Plug your kindle into the wall charger, a yellow light will light up. When the yellow light turns green, your kindle is fully charged. Then try turning on your device. If the device still does not turn on, hold the power switch for 15 seconds, this will reboot the device.

THe pc is short or the light module is faulty

There is an old message stuck in memory. Hold down the OFF button on the base handset for 10 seconds.

Try adjusting the convergence. If it won't move see below- red IC in particular
This sounds like convergence output IC problem. convergence board would have to be removed - remove and replace 2 STK IC's and check the surrounding resistors. Shops usually charge between $200-$400 Be sure to vote/rate me if this helped Thanks!
See link for more detail
http://www.ehow.com/how_4575598_yourself-projection-tv-repair-convergence.html

Once you get a dead pixel (black dots), there is no way to repair that part of the screen

1. Press and hold the TIME button for 2 seconds. The green TIME light will come on and display will read 12:00. The unit is now in the timer programming mode.
2. Press "HR" and "MIN" button to program start time. Small dot in upper left corrner signifies clock is programmed for A.M. No dot in upper left corner means clock is programmed for PM.
3. The Timer Display and LED light will flash 5 times to indicate that timer is now set. Press and release the TIME button. The green TIME light will come on.
   

you can try demagnetising your tv screen