How to install KLH asw10-20 to a 7.2 receiver

Low level inputs are designed to take signals directly from an amplifier's "sub out" connections. That way the KLH amplifier will use those signals to produce sound and the volume can be balanced between the main amplifier and the sub amplifier using the sub's volume controls. Depending on your amplifier and sub, that is the best way to connect them. However, be careful running the RCA cables since the low levels are more subject to interference. Keep the runs as short as possible and use high quality shielded cables for the interconnects.

Here are the codes for a RCR312WR remote:

KLH: 10765

source: http://www.rca.com/support/remote-control-support/#

Here is the code for a RCR312WR remote:

KLH: 10765

source: http://www.rca.com/support/remote-control-support/#

what kind of speakers do you have hooked up? make sure your cables from the speakers are good. you should have an RCA type hookup on your record player, make sure they are in there good too

HI,
Check the following link you will get the answer why There is no manual avilable for KLHr5100. Still i dont have the manual for this one.
http://www.epinions.com/review/pr-KLH_R5100_5_1_Dolby_Digital_DTS_Channel_Home_Audio_Receiver/content_554691628676

Ajin

Hi,
I don't have the manual with me. I found KLH R 5100 with user manual in the following link. Tray to contact them.
OK
http://www.ebay.com/itm/KLH-R-5100-Receiver-Hi-Power-/250902259353

From your description you have bad connections on the display board, or intermittent power feed from the main board, it will take somebody that is handy with a soldering iron or a professional to check it out.

Yes if your sub will let you do that. It should work fine but it may decrese some bass from your two sat. sperkers.

For Stereo Mode (Front L & R Speaker), you must plug RCA cables (match up red and white) from Output on DVD player to DVD Input on the back of the receiver. Then with speaker wire, run from receiver speaker output (Front Speakers) to designated speaker (make sure + and - match up to both input and output). As for hooking up surround sound, I'm currently trying to figure that one out with just using the L, R and Center. I don' t want wire running all over the place just for rears. Hope this helps