My GE HE top load washer quit draining & spinning. I*t went through a wash cycle just fine. It drained & spun for that, but at the end of the rinse cycle it wouldn't. I even tried to put it on

sounds like a bad computer board

sound like the water pump is shot

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing Machine not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101

I have a Kenmore washer that will not spin or drain.

Sounds like you need a new drive belt.

Sounds like the pump went out. Top loaders are in the rear of underneath and front loaders are behind the front panel.

water pump blocked with nylon stuffing from old pillow.removed front panel from hinges under the lid. water pump at the right hand corner removed hose then removed 2 cups of nylon threads and stuffing forced into pumps small openings where it was compacted to a solid mass.

my hot pointtopload will not spin or wash

thanks for posting problem solve :0)

Jayron, is the motor jogging? start to spin, stop, start to spin stop. If so, your motor is jogging between the high and low start windings. The motor during spin should start on the high speed windings and stay there until most of the water is drained. GE came out with a new motor, harness and run cap because of this. If you have a meter, there should be a white and white/red wire going to the motor. If you have a steady 120V and it's doing this jogging, replace the motor with the kit...Let me know if this the issue, Catriver..post back.