My headset was working 30 minutes ago - now when i try to use it all I hear is a buzzing sound??

maybe a fault. Try charging it a lttle more n leave it on a bit longer? if not you may have a duff one so just take it back!

the mic will have no problem.check if the connection are ok

hey man, i have the same problem too. i tried using 2 brand new headsets for my 5530, but still, it didn't work. and the person i talk to during calls can't hear me with my headset. :' it sucks :'

Hi,
It sounds like your motor has gone bad....it will buzz really bad when it is tring to start and cannot...

http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning

heatman101

Asker's Testimonial " Thanks so much for your help. Now that you'v mentioned it, the buzzing does sound like it's coming from the motor. I'm,now, more comfortable in call " -

If you're using the Play n Charge kit, then you might be hearing some buzz/whine through the USB power. Use the X1 without the Play n Charge. Does that help?
If you unplug the chat-controller cable from the X1 volume control box, can you now hear shots and explosions without the annoying beeping/buzzing noise? If so, then you may have a bad chat-controller cable, and you should have it replaced.

Hello.

I had the same problem for like ten minutes ago. I have a Swedish Vista computer and don't know all the translations but I'll give it a go.
This will reduce the buzzing not remove it.

Go to the control panel and click "sound". From there go to "recording" And double click on the microphone. You should get a new screen up. Click to the second button "Levels". Now drag the "microphonestrenghning" (the bottom one) and drag it down to 0 DB.
(optional) Drag the "Microphone" up to 100.

Hope this help you. It worked for me at least. :D

Alexander

try going to the settings of your BT headset... hope that works

Your phone may not be set up to use a headset. You need to look into programming for headset mode. If this is helpful, please post as such.

try pairing the bluetooth device to another phone, i had the same issue, i used a different phone for testing. it works, so i paired it to my phone and it also works

I was also experiencing the same problem (also after a power failure / storm) -- apparently good battery charge, connections ok, etc. I then tried removing the battery from the headset itself, waited 30 seconds, and then reinstalled the battery. This seems to have resolved the problem.

It is fairly easy to open the clamshell, but you will need a very fine Phillips screwdriver to remove the battery hold-in (it's really not a hold-down, it just keeps the battery in place. Reassemble the same way -- be sure to keep positive to positive and negative to negative.