The picture is going pink on 55 inch plasma. How do I fix it?

I don't know how to fix your issue but I have the same tv with a cracked glass front. I would be interested in buying your tv for parts to replace my glass front if you are unable to fix yours. Please let me know. Thanks, Dan
[email protected]

If you take the back off you might see a couple of electrolytic caps that might be bulged on the power supply board. The power supply board is getting weak, and if you replace the electrolytic caps that will fix the problem. You can also replace the power supply, and you can check at www.partstore.com for a power supply.

after changing the lamp, I still had the same problem as you. I contacted sony and they offered me a brand new 40 inch bravia flat screen tv replacement...at no cost! If I chose a 46" or 55" there would be a charge between $325

Try re-seating your upper and lower buffer board connectors. These boards run the length of the set on top and bottom. Since your line is from the top going down I would check that one. The connector will be close to where the line is showing up on the screen.

take the color to b/w and retune

Hope you already resolve it, if not, here what I went through 1. go to http://www.service-docs2.com or similar place to get a service manual for your model ($10-18) 2. Open the back and follow instructions how to remove and test the SDR-D and SDR-U board on the far left (take one off, see if you could see half the picture). Inpsect the chips on those two boards, you might be able to spot the burned out holes (that would be the defected board, seemed to be a known issue for particular models) 3. If it is the board, go to ebay and get the pulled out board replacement ($70-90) I fixed my 50 inch plasma this way

If your using Component input, double check your Red-Grn-Blue jacks. Let me know.

Hi there, Im Kanth, i had the same problem, and i found a person in Mississauga, they fix all kind of problems in Plasma, they fixed my LG before a 7 months, its still running good, i came to know lots of ppls were having same problems, i sujest u to being the plasma to electronics @ Dixie and Britannia Mississauga, call them now 905 565 6595 or check there wesite for more info. http://dukeelectronic.com