Door open indicator light stays on in my 2010 Nissan Rogue.where are the door jamb switches located?

You need a replacement door switch.

2007 Honda CRV Door Jamb Switch - from $5.99+ - AutoZone

https://www.autozone.com > ... > Door And Door Parts

Equip cars, trucks & SUVs with 2007 Honda CRV Door Jamb Switch from AutoZone. Get Yours Today! We have the best products at the right price.

Honda CRV Door Jamb Switch - AutoZone

https://www.autozone.com > ... > Door And Door Parts

Order Honda CRV Door Jamb Switch online today. Free Same Day Store Pickup. Check out free battery charging and engine diagnostic testing while you are in ...
US$7.99 · ‎In stock

Genuine Honda CR-V Door Jamb Switch

https://www.hondapartsnow.com > Honda CR-V

Genuine Honda CR-V Door Jamb Switch. Door Jamb Interior Dome Light Switch. Enter your vehicle info to find more parts and verify fitment. Select Vehicle ...

Genuine Honda 35400-S5A-013 Door Switch Assembly

https://www.amazon.ca > Genuine-Honda-35400-S5A-...

Genuine Honda 35400-S5A-013 Door Switch Assembly in Interior Switches. ... Took just 5 minutes to replace my drivers door sensor on my Honda CRV 2009.

..

one of the doors have a bad sensor or boor button it should be located on the door itself or around door jamb of vehicle. .

There is a tiny switch inside the door called the "Door Ajar" sensor, remove the door panel and replace that switch, it is attached to the door latch, it just twists out and back in.

At least one of your door ajar switches are sticking. Try spraying rust penetrant into the latches and open and close the doors several times. If they still stay on you will have to locate which latch it is by removing the door panels and disconnecting the switches.

Door jab switch is bad,it is in the door latch.

Hi there,

I had a Saturn that did the same thing. It turned out to be one of the switches in the door jambs was broken. The fix was less than five dollars.

Check the switch for each door. Let me know what you find out. We can proceed from there.

Mike

Check all the switches at the door jambs. Switches can get pushed backward out of their mount or can even go bad or have bad wire connection.

If I am not mistaken, the plunger is located in the door with the latch. Most of the time you can just pull the door panel off and adjust the switch. After opening and closing the door, they get knocked out of adjustment. I sincerely hope that this helped you. Take care and best wishes.
Bryon

check each door jamb button (can't think of the correct term). close all doors except one... push the button manually... does the interior light go off... if it does move on to the next door. that will narrow down where the problem is... or it should. it also could be the relay for the interior lights located on the fuse panel under the dash.

Robert

I had this problem on my 2003 explorer and took WD40 and gave the lock mechanism a good dose where it meets the clasp on the door jam. Then open and close the doors a couple of times to get them working. They get gummed up and sometimes have a tendency to stick.