SOURCE: Overheating YAMAHA XLT 1200 jet ski
you may have something clogged in a water passage but more than likley u have a bad sensor the sensor is located on the main exhuast if you go on the right side of the ski and look in the engine compartment it will be located at 9 oclock u will see it sticking out of the exhuast with one wire comming out after u run the ski and the buzzer goes off pull the seat and see if the engine is really hot if u can not touch it will be hot but it has to be very hot for the sensor to pick it up if u can touch the motor and exhuast it is a bad sensor
SOURCE: how do we start a yamaha 1998 xl 1200 wave runner
first put a new battery in it. then put your lanyard in the handle bar clip push the start button make sure that you have a life jacket on when your in the water and make sure that u attach the lanyard to your wrist or life jacket
SOURCE: does a yamaha wave runner have to be in the water
no but do not let it run for more than thirty seconds out of water and dont rev over 3 thousand
SOURCE: 95 yamaha wave runner starts
Have you changed the 'fuel filter'. That's where you start.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c
SOURCE: yamaha 1200 wave runner water in the cylinders
It could be. Do a compression test to ensure that each cylinder is achieving compression, and ensure that the engine does not make awkward noises during cranking.
If the engine was stopped manually, chances are it was not affected at all by the water. Change the oil, however.
1,049 views
Usually answered in minutes!
×