Trailmaster 150 xrs will not go into reverse - Vehicle Parts & Accessories

Buya clymermanual for total repair..n gitta good lock for that classic..ibelieve tho it has a steering lock

Found one here:

Cobra XRS 9990 User Manual

change the reverse polarity diode.

Did you first check the fuse in the units power cord? The fuse should be in the part of the power cord that plugs into the lighter socket. A 2 amp fuse should be good enough.

There is a three position switch on it. When it is pressed in one direction it moves in front direction and witched to other side the it moves to reverse.

It means that your switch might be faulty.Replace it.

Timing Chain and Gears Removal & Installation To Remove:


Except XRS

XRS

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Drain cooling system.
3. Remove the upper front fender apron insulator.
4. Remove the upper radiator support insulator.
5. Remove the right front wheel and tire assembly.
6. Remove the right lower splash shield.
7. Remove the drive belt and alternator.
8. Remove the air switching valve (XRS)
9. Remove the power steering oil pressure switch connector.
10. Remove the 2 power steering mounting nuts and through bolts. Remove the steering pump from the engine. Secure the steering pump to the cowl
    
    
11. Raise and support the engine with floor a jack.
    
    
12. Remove the right engine mount.
    
    
13. Remove the 2 nuts, 2 clips and the cylinder head shield (except XRS).
14. Remove the 4 ignition coils.
15. Remove the 2 ventilation hoses from the cylinder head valve cover.
16. Remove the 9 bolts, 2 seal washers, 2 nuts, cylinder head cover and gasket (except XRS). XRS
    
    
17. Remove the 4 bolts and the cylinder head shield (XRS).
18. Remove the 2 nuts, bolt and remove the ventilation hose from the ventilation pipe (XRS). XRS
    
    
19. Remove the Ventilation pipe and gasket (XRS).
20. Remove the 9 bolts, wire harness protector. Remove the cylinder head cover and gasket (XRS).
21. Remove the O-ring from the cylinder head cover (XRS)
22. Turn the crankshaft pulley and align its groove with timing mark "0" on the timing chain cover.
    
    
23. Ensure that the marks on the camshaft timing sprockets are in straight line on the timing chain cover surface as shown.
    
    
24. If not turn the crankshaft 1 revolution (360°) and align the marks as above.
25. Remove the crankshaft pulley
    
    
26. Remove the 2 mounting bolts and remove the crankshaft position sensor.
27. Remove the mounting bolt, nut and the drive belt tensioner.
28. Remove the right engine mount bracket.
29. Remove the front exhaust pipe (XRS).
30. Remove the Exhaust manifold brace (XRS).
31. Remove the Exhaust manifold (XRS)
    
    
32. Remove the 2 mounting nuts and remove the chain tensioner.
33. Remove the water pump. Except XRS
    
    XRS
    
    
34. Remove the 11 mounting bolts and nut (except XRS).
35. Remove the 12 bolts (XRS).
36. Remove the stud bolt.
37. Remove the timing chain cover and 2 gaskets.
38. Remove the crank sensor plate.
39. Remove the timing chain tensioner slipper mounting bolt. Remove the tensioner slipper.
    
    Note: If the crankshaft timing sprocket cannot be removed by hand, use 2 screwdrivers. Position shop rags as shown to prevent damage.
    
40. Remove the timing chain and crankshaft timing sprocket.
41. Remove the 2 chain vibration damper mounting bolts. Remove the vibration damper
    
    
42. Hold the camshaft hexagonal section with a wrench. Remove the sprocket mounting bolt.
43. Remove the valve timing controller assembly and timing sprocket.

Note: Be careful not to damage the cylinder head and valve lifter with the wrench.
Do not disassemble the valve timing controller assembly.

Radars are like just about anything else you buy these days, you get what you pay for. If you want a cheap but most reliable for the price I would suggest the Whistler XTR-695 *est. price 150 bucks. Although many detectors are prone to being detected by radar detectors (used by law enforcement) this one is a little more likely. So if your state has a ban on radars I wouldnt buy. As far as distance in signal pick up the Valentine One I would go with *est.price400 bucks.

The Cobra XRS-757 is the same as the Cobra XRS-9330. The difference in model number is due to the 757 being sold at Wal-Mart stores.

rover vitesse has shut down all ignition lights no power to starter

http://www.cobra.com/downloads/manuals/XRS9630_MANL.pdf