Does waiting to rreplace the battery effect the machine?

The design of principles of diesel generator parallel system

The design of parallel optimization system for diesel generator sets adopts a parallel machine scheme with load distribution function for parallel machine monitoring system and parallel cabinet, it can be better to apply to large-scale parallel systems. We can accord to different requirement, for example, if apply to start-up of large power generator, the system can provide pre-start to meet the requirements. Aiming at the strong, weak and electromagnetic interference problems in parallel system, the design should use software filter and hardware filter to solve the problem. Adopt CAN bus methods to compare the digital quantities to achieve more effective active power allocation, this can avoid adverse effect to active power distribution by voltage loss in voltage load distributor.Aiming at different generator types to design and ensure reactive power distribution form. Aiming at the generator that uses AVR pressure regulating template, its reactive power distribution adopts software programming to increase voltage feedback to offset the adverse effects of temperature drift. In order to avoid impact on generator. In the parallel system, a zero power conversion design scheme is provided, that is, automatic synchronization between genset, zero power working for newly added genset, and then load transfer and average distribution are carried out smoothly according to the setting.

Joe,

The heat from the fireplace can have an adverse effect on the life of the batteries. Sometimes simply re-positioning the receiver to a cooler location under the firebox and/or adding a heat-shield can improve battery performance with the Skytech remote receivers.
As a test, you could even place the receiver outside the fireplace for a period of time to gauge the effect of heat on the unit.


According to the owner's manual for the Skytech 3301 Thermostat Remote:


"For REMOTE RECEIVERS that operate on BATTERY POWER, these heat conditions can cause batteries to discharge when temperatures exceed 115 degrees F. Studies show that alkaline batteries, when exposed to a constant temperature of 120 degrees F, can lose up to 50% of their operating power. When the battery cools down, it will partially recharge itself, but constant heating and cooling will reduce the battery's normal life expectancy."

Hope this helps!

Oftentimes the check engine light will come on with no adverse effects. the computer may have detected an intermittent problem. The light may go off on it's own it a few days. I would recommend "scanning" the system and retreve the trouble code and determine what is really wrong.

you can replace battery with out effects.first turn off radio.before removing negative battery cable.when you install new battery, when you start the engine let it idle until get operating temperature.the computer will have to relearn it memory while engine idling operating temperature.open throttle a little see if engine hesitate. it will hesitate some, when you can accelerate with out hesitation,engine tps sensor has relearned it position.if idle speed stable engine dont run rough and stall out in drive your pcm has relearned itself where you can drive it.

Hi,

I had the same thing happen to my A590. I found the problem with mine was a micro swtch inside the battery compartment. open the battery compartment and you will see the small white tap that is supposed to get pressed when you close the door. I took mine apart and wedged the end of a toothpick under the tab and mine has been working fine ever since. I haven't been able to get an answer as to what the purpose of this switch is but it's been about 6 months and I have seen no adverse effects from my repair.

Good luck,
Bob

NO, that an extra on your car, just to let you know how fast your engine is turning, has nothing to do with emissions.

Here is the help page from Microsoft regarding this issue. They don't list a fix for it but they also state that it shouldn't adversely effect the machine. If it IS causing operating issues with your machine please post the details here.

I had exactly the same problem with a 3 month old Zumo 550. Removed battery, waited a few minutes and replaced. System now poers on OK. All data on-board was retained.