Clean light blinking will not start

This is caused from a power cut or by the door being opened during a mid cycle.Or from a power cut.

possibly the filter...

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Hello. Most likely, the humming sound you hear is a jammed drain pump which is activated immediately to pump out any stale or standing water below the level which you can see. Then, fresh, hot water enters the tub to start washing the dishes. I need the model number and exactly what lights are blinking--those blinking lights are error codes(combinations of 2 or more lights, one light blinking a certain number of times, then blinking again, a different number of times--ex 3 times, then 7 times) the lights blink a binary error code--thats why I need the model number to look up the code on the chart

Sounds like the control board or panel is shot. What is the model number of the unit, and serial number?

May have a bad heater. press hi temp, air dry,hi temp, air dry (or whatever button is equivalent on your model). this starts a test and will allow unit to work again. When drying light goes out touch the heater. If it is cold then it may be bad. You will need a voltmeter to tell for sure however.

i need help with this same problem

replace timer/program module Vitally

press heated dry
press normal wash
press heated dry again
press normal wash again..........
.....wait a few seconds
all the lights should come on
press cancel (should hear pump)
hit cancel again

Hope this helps, it worked for me, but it may depend on your model.

It says in the manual to check the heating element.

A blinking light, and possibly no lights, with the door closed may indicate faulty door switches (very common on newer models). Depending on the model, the switches can be removed, cleaned and put back