Photo cell goes on too eary and off too late. any suggestions?

If it's a First Edition, it does not have that capability

You should check that you are using compatible ink for the printer that you are using and that you are selecting the correct paper type in the printer properties section when printing.

1964 ,,very eary indeed but its a american car which is not a problem but iam not familar with it as on our europeon cars of this time they never used starter with a solonoid on top (pre engaged) but a inertia centrifugal throw out one ,if this later one is used then i think it will need a special heavy duty solonoid that bolts into the inner wing ,wire from switch goes to this and the + from the battery goes to one aide and the other to the starter ,quite simple but have you got all the right parts if it is this type

Unknown if this is new installation, or old installation that went bad.
Old install, then check voltage is correct for rating plate, check that line power is not under-voltage, check that photo control receives enough light by shining 120Volt light bulb onto photo eye, replace photo eye
New install, check wiring. Photo cell has 3 wires, For example Black White and Red.
Black and White connect to power source, and Red goes to load.
http://waterheatertimer.org/How-to-install-and-troubleshoot-photo-eye.html

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Open iTunes then Drag photos from the photos folder on your iPod to the desktop.
On the other hand you use the following link
http://www.ipodpctransfer.com/pictures-ipod-computer.html

I am glad to find a real Audiophile and I fully agree with you for the quality that analogue tracks give out.
The arms mechanism needs a resetting as when the arms comes to the end there is a link to detect and make the arms to be lifted up and brought back like a clock work. so there is an issue here which needs attention - mechanically. You need to look inside the unit, manually turn and find the fault.

check out ur phone requirements like its capacity of micro sd card like 1gb if u cross that limit u will not get full acess ur phone becomes slower or pictures opens late or music play late otherwise check ur phone settings that it is in storage of memory card or phone....

Try using #10 paper. Don't use Glossy.
Good Luck.

Take a look at the manual - sounds like you have accidentally changed the white balance setting - you will want to set it back.

Try cleaning and putting a small quantity of oil the shiny metal bar that the print heads slide along. Take care not to get any oil on the rubber drive belt. Any thin oil for sewing machines or bicycles will do, even WD-40 or 3-in-1 on a tissue is fine. This is probably too late for the questioner, but someone may find it useful.