Question about Onkyo Tx-nr616 7.2 Thx Certified Network Receiver <<< Pre-order >>>
Posted by Anonymous on
The amp protection circuit has been activated. Remove the power cord from the wall outlet immediately. Disconnect all speaker cables and input sources, and leave the AV receiver with its power cord disconnected for 1 hour. After that, reconnect the power cord and reconnect an input and a pair of speaker wires onto the unit. If the receiver still does not turn on than you will have to bring it in for service. Turn up the volume and if the receiver doesn't shut down, power off the receiver and add another pair of speakers. Power up the unit again and turn up the volume. If it doesn't shut down, power off the unit again. Now connect all your input sources and turn on your receiver. If the unit shuts down again, your unit will need to be further serviced at an authorized Onkyo service center.
Posted on Oct 11, 2014
SOURCE: Onkyo TX-DS989 not staying on
This sounds like the action of some protection circuit that is monitoring some condition or voltage that isn't within its design limits. If it was mine, I'd look for an Onkyo forum to see if others have experienced the same problem.
Posted on Jan 08, 2009
SOURCE: i have an onyko receiver
have you ckeck the tv config??
sometimes u need to select in the tv menu, in audio option to have continue output, otherwise when you turn the volume up in the tv the amplifiers sounds more, have you try this??
or check the cable maybe is damaged.
Posted on Jan 25, 2009
If the unit is under warranty, DO NOT open it up. Bring it in for an exchange or warranty service. Explain that the unit makes noise during use and it will be serviced. This could be as simple as a bad connection in the power supply area and you are hearing oscillations or it could be a defective power transformer. Either case will be covered under warranty so there should be no charge to you.
Keep us posted.
Posted on Feb 17, 2009
When unit is on hold down vcr button and press standy power button. display will read 'CLEAR". turn back on and see if remote works. note that this will erase any of your settings. Point the remote at any camera and look at the camera display. If you see a white light when you press buttos remote is working. Remove the top cover, remove front cover and resolder connections on remote receiver. If you intend to do this let me know and I can give you more details.
Posted on Mar 26, 2010
get an rca y-splitter for the sub out, and you can run a signal to 2 subs
Posted on Mar 23, 2013
Testimonial: "thanks it is working just fine..."
Tips for a great answer:
Feb 22, 2015 | Onkyo Audio Players & Recorders
Feb 07, 2015 | Onkyo Audio Players & Recorders
May 01, 2014 | Onkyo TX-8511 Receiver
Mar 23, 2013 | Onkyo TX-SR608 Receiver
Dec 31, 2012 | Onkyo TX-SR705 Receiver
Sep 24, 2012 | Onkyo Tx-nr616 7.2 Thx Certified Network...
Aug 24, 2017 | Onkyo TX-SR303 Receiver
Jun 19, 2011 | Onkyo Audio Players & Recorders
Jan 10, 2009 | Onkyo TX-DS575 Receiver
655 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: