i have been looking for a solution on this site and others....
but have had no luck.
i just bought a set of non-working logitech x-230 spekers and have no sound comming out of them......
i knew this problem when i bought them.... thinking i could repair them....
the green light comes on....
i have a working set of these same speakers,and i have narrowed it down i think to the sub.
is there a schematic for this item....
or might you know of the problem? and how to repair it?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
configure ur PC (both OS audio and third party sound driver) for surround sounds. control panel- sounds and audio devices - speaker settings - advanced - speker settings. so this done. make sure u select the 6 input channel - the button is on the right edge near the volume knob. near the vol button there are two buttons for selecting input type with up down arrow. from that u can select the input type this will be indicated on the top front indicator. but with the 6 input channel selected all selections are preceeded. if u select stereo mode u will have left/ right audio only. make sure u connect the input right. connect from computer to 6 channel input. main, surround, center and sub-woofer. connect the spekers to main (L/R), rear(surround) (L/R), center and sub woofer to terminal marked sub woofer ouput. this done select like i said before the 6 channel button. that should do it.
Hi there , the green light just means its getting Power, it doesnt mean that its going to give sound, It could be that you dont have Drivers installed for your Sound card which is causing it too not get sound , but when it makes that static noise , its the Wire just causing Static with the Sub , just means its getting power , The + and - sign is the volume control ...Try see if you can turn it louder with the + . maybe it is low enough not too hear.....Hope this helped Bud Happy new year.
To answer your question;
There is no problem in using both subs at the same time.
As a matter of fact you could split your signal in ten and have a sub for each one of them.
You`ll just have to set the subs levels so they match each other and i`d say the more sound to the larger sub.
Just try it at different sound level and you`ll find the correct setting.
Have fun Happy holidays
Here's a link to www.modifiedlife.com which will have a page showing the color codes for your vehicle wiring. The 2008 Chrysler 300 rear speakers are shown as follows: Left positive is Dark Green/Tan, Left negative is Dark Green/Gray, Right positive is Dark Green/Brown, and Right negative is Yellow/Green. Other models and other years will be different, so be sure that you browse to the correct color codes for your specific vehicle.
Hope this helps.
you have to check if all the cables are well connected, and in the right inputs. 2) check your software for sound that is enable, fine.
turn up the sub volume , if got it independent.
other that this, is a failure sub. if got warranty, use it! or RMS your sub.
You should adjustb it to what sounds good to you, as industry standards with a sound pressure meter says to start out at 0 db level. You should read this link and others at this other site. http://www.techlore.com/article/10037/