Question about Electrolux Freezers

1 Answer

Why is the pilot light on my ERN7926 frost free flashing?

ERN7926 is not cooling and the pilot light is flashing. It sound normal.

Posted by Anonymous on

Ad

1 Answer

Dado

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.
    Master:

    An expert who has achieved Level 3.

  • Electrolux Master
  • 509 Answers

To Start the Appliance
Allow the appliance to stand for 2 hours after
installation. Plug in the appliance and switch on at the mains
supply. Turn the thermostat control (B) to a midway
setting and adjust the slider control, situated on the
back wall of the fridge section, to a midway position
between "MIN" and "MAX".
The pilot light (A) will illuminate. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside.
To switch off the appliance turn the thermostat
control to position "?"

After 4 hours, measure the temperature in the refrigerator and freezer. Should be between 2 and 10 degrees centigrade in refrigerator and app. -18 in freezer.

Dado

Posted on Jan 06, 2015

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is Zanussi frost free freezer alarm always flashing
Because it does not achieve the correct temperature (for example: -18 degrees centigrade).
For a more precise answer I need more information.
A lot of things may be incorrect:
- Doesn't work defrosting cycle
- The cooling fan is not working
- Too much ice on the evaporator battery
- Faulty thermostat or NTC sensor
- Faulty cooling system (gas leak)
- Compressor
- Electronic

Dado

Aug 26, 2014 | Zanussi Freezers

1 Answer

Left door open, closed next day, but only blowing cool air now
You will need to turn the unit off and let it completely unthaw. There is frost that builds up in the ducts and behind the panels when the door is left open that will cause the unit to not cool or circulate where needed.

May 10, 2010 | Frigidaire 20.3 Cu. Ft. Frost-Free Upright...

1 Answer

The freezer is not cooling
If this is not a frost free freezer to determine which component has failed please do the following.

Unplug the freezer wait 5 minutes and plug back in. Listen closely for any sounds by the compressor. If you hear a click or hum followed by a click the problem is the compressor and would cost about $400.00 to repair.

If you do not hear any sounds the problem is most likely the cold control or sometimes called the thermostat2_bing.gif.

If this is a frost free unit the problem could be with the defrost cycle or the fan motor.

Apr 26, 2010 | Kenmore Freezers

1 Answer

Each time i open the fridge door and the the fridge mtr is runing, the buzzer sounds on and off and lights flash
The circulator fan shuts off when the door is open to help prevent the evaporator coil from frosting up and reducing efficiency from the inrush of warm humid air. This is normal on some models.

Mar 18, 2010 | Freezers

1 Answer

Both Lights flashing and fridge not getting cold
I turned the fridge and freezer off using the circular dials, I then turned the unit off at the mains. Left it for a few minutes and then turned the power back on. I then turned the circular dials to "max" and then depressed the super cool and super freeze buttons to turn this facility on. This time they came on normally (not flashing) and no alarm sounded. The fridge and freezer then started to get cold. Once the unit had been running for several hours I then turned the dials to the 3/4 mark and depressed the super cool and super freeze buttons again to turn them off. Over night the fridge and the freezer appear to be working properly so I hope that my problem is solved. Maybe the unit just needed to "settle" before being switched on?

Sep 03, 2009 | Freezers

1 Answer

FROST AND ALARM LIGHT ON
Your defrost timer, switch or circuit board is probably shot or it would be defrosting.

Use a fridge / freezer thermometer to tell if temperture high (it should be 0 F plus or minus 5 degrees) to determine if it is too high - this is normal if frost builds up but will get worse unless repaired.

May 04, 2009 | Hoover Freezers

1 Answer

Freezer only freezing to 20 degrez
If the door was left ajar for any extended period frost has built up on the cooling coils. A complete defrost of the freezer should take care of the problem. Normally a frost free system will clear the ice from the cooling coil when the defrost time cycle happens. However frost may have built up in areas where the heaters can not readily remove it in a normal defrost cycle and shutting the unit down with the door open for about 24 hours should clear it out.

Nov 27, 2008 | Freezers

1 Answer

Ice build-up
Defected DEFROST HEATER can cause frost build up on the panel at the back of the freezer,and freezer stop cooling and ice frozen on unit so air could not flow to refrigerator side.Water will coming out caused of unbalanced freezing,and causing the flooding of water in the floor. You must change this defroster heater assembly so it will works normal again..


Hope this may help;

Regards,
VOTIT

Sep 22, 2008 | Frigidaire 20 cu. ft. / 566 liter Upright...

1 Answer

Fan continuously running, non-stop
hi thanks for the question its normal for a frost free freezer to run a long time to keep a good cold temp i don't think you have a problem thanks the appliance doc

Sep 08, 2008 | Frigidaire 13.7 cu. ft. / 388 liter...

2 Answers

Temp alarm going off
What is the temp in the freezer, sounds like temp is to low..no water should be coming out of freezer, sounds like may be defrosting Need to check the temp to make sure its cold enough.. thats what that alarm is for

Aug 10, 2007 | Kenmore Freezer 20.3 cu. ft. Frost Free...

Not finding what you are looking for?

View Most Popular

Freezers

Related Question

Why is Zanussi frost free freezer alarm always flashing

  • Zanussi Freezers

Open Questions:

0 Answers

how to change belt

Dec 13, 2015 | Electrolux Nimble Vacuum

0 Answers

Ice maker making huge chunks of ice

Jul 08, 2015 | Electrolux Frigidaire Gallery FGHB2844LF...

0 Answers

Won't turn on. The button is lit up so we know power is making it to the machine but nothing happens when pressing the on/off switch. Have checked to make sure canister is installed correctly and is clean.

Jun 25, 2015 | Electrolux Nimble Vacuum

0 Answers

My Electrolux freezer model EUC3003 is showing error code 11 what does this mean?

Feb 14, 2015 | Electrolux Freezers

Freezers Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

1 Answer
My upright freezer temperature won't go below 20

Electrolux Upright Freezer...

1 Answer
I have an Electrolux Intuition Chest Freezer. The

Electrolux Freezers

3 Answers
Control board and wiring harness which are

Electrolux Frigidaire...

1 Answer
Exclaimation triangle red light is on - Electrolux CUU6174

Electrolux 3.53 cu. ft. / 100...

1 Answer
Re lights lit on freezer

Electrolux Freezers

Top Electrolux Freezers Experts

Dennis Boxerman

Level 3 Expert

1305 Answers

washington munene

Level 1 Expert

15 Answers

ray gallant

Level 3 Expert

71004 Answers

Are you an Electrolux Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
Http://www.electroluxusa.com/files/int...

Electrolux 16.8 cu....

PDF Manual
Http://www.electroluxappliances.com/Fi...

Electrolux Upright...

Loading...