What is the temperature sensor on the cabrio dryer?

Question moved from Cars and Trucks.

The Whirlpool washer F3E2 error code is a temperature sensor error. You can check the temperature sensor with an ohm meter to verify the sensor is bad. ... The correct ohm reading should be between 500-100K ohms, if not the sensor is bad and needs to be replaced.

Whirlpool Washer F3E2 Error Troubleshooting and Repair

Inlet temperature sensor (thermistor). Could be a failed thermistor, but thoroughly check the entire dryer exhaust for blockage (severe lint build up) inside dryer all the way to exterior vent.

Try this YouTube link:
https://www.youtube.com/results?search_query=Whirlpool+Cabrio+7.0+Cu.+Ft.+Dryer.+where+is+the+Moisture+sensor+location

Hello Shirelle,
The door lock mechanism is defective Or the door seal is seating properly.

Start Switch is bad, When they go out it leave's a open circuit and all light will come on but no action.
After the circuit is closed then it tells the dryer to start cause the circuit activates both the timer and the motor.

Good Luck

Mike Z

Click sound at power button and start button should get it going. If not then Dryer drum is not turning.

Just might be your temperature switch is bad.

Check temperature sensor.  Check to see if heating element is OK.

have a problem with my cabrio dryer its powered on but when i push start the sense like comes on and does nother whats the problem