What is the charger part for JNC300XL jump starter

Here are the steps to replace the charger for the Power On Board 450 amp VECO12POB jump starter:

1. Unplug the charger from the electrical outlet and remove it from the jump starter.
2. Locate the charging port on the jump starter and remove the cover.
3. Disconnect the old charger from the charging port by gently pulling it out.
4. Take the new charger and insert it into the charging port until it clicks into place.
5. Replace the charging port cover.
6. Plug the charger into an electrical outlet and charge the jump starter according to the instructions in the user manual.

Note: Be sure to use only the manufacturer-recommended charger for the Power On Board 450 amp VECO12POB jump starter. Using a different charger can damage the jump starter and void the warranty.

The voltage required for a 300amp jump starter by Endurance will depend on the specific model you have. It is best to refer to the manufacturer's specifications or consult the manual for the correct voltage requirement for your jump starter. In general, you need a 12V DC power source, such as a car battery, to use a jump starter.

Hi Richard,

The item you have is a "SCA 12V Jump Starter - 8 Cylinder, 1900 Amp" (Model PJS1900AL) which is sold by Super Cheap Auto with locations in Australia and New Zealand.
https://www.supercheapauto.com.au/p/sca-sca-12v-jump-starter---8-cylinder-1900-amp/562417.html

The Part you lost is the "240V Charger Adapter"

You need to contact Super Cheap Auto, provide them with the following information, and ask them how to get a replacement "Charger Adapter" for the Jump Starter

Item: SCA 12V Jump Starter - 8 Cylinder, 1900 Amp
Model: PJS1900AL
Part: 240V Charger Adapter

Contact info -
Super Cheap Auto
Ph (07) 3482 7500
www.supercheapauto.com.au (AUS)
www.supercheapauto.co.nz (NZ)

http://jumpstarterexpert.com/everstart-jump-starter-review/

Everstart Maxx Jump Starter and Battery Charger Review UPDATED 2018...

Since you are looking for new charger for you husband, I would advice to buy these lithium chargers only as they are far more compact than traditional ones and are safer to use.Lithium jump starters are new and different battery chargers from tranditional ones. They were introduced in 2013. Amongst the recommeded ones, I would advice you to buy PowerGo or DB power jump starter as these are the most powerful and affordable ones. Best Lithium Ion Jump Starter to Buy in 2018 CarHq Car HQ

Then contact Amazon.

Since most of those chargers are just simple current chargers it is best to not leaving on it all the time. Plug the charger in to the Jump Starter for about a day or two and then unplug it. About a week later plug the charger in for a day, then unplug it and do it again next week.

UpBright AC Adapter Charger For Vector 450 Amp Jump Start System...

This is a generic charger cord listed by Amazon specifically for the Vector 450 Jump Starter.

Need confirmation that the AC adaptor for Duralast jump start model BP-DLG is a 12volt 450ma. Is this correct or do I need something else?