Magnum delta force radio wiring diagram for Mic turner 2pluse 2

Must know the pin out of the transceiver your wiring it too.
like cobras 1.ground 2.audio 3. TX 4. RX... then wire accordingly.(same as the 4 pin exports)..
Use a ohm meter to find the correct wires on your mic switch.
then you know how to wire any mic to any transceiver.
This will work for the turner 2+2

Notice the black mic plug has the numbers it is solder by numbers. Used rosin core silver solder radio shack sells it.
Mic Wiring
Stock
1-Shield (ground)
2-Yellow (audio)
3-Red (transmit)
4-White (receive)

Astatic
1-Shield & Blue
2-White
3-Red
4-Black
Yellow NC
Turner Roadking 56
1-Shield & Red
2-White
3-Blue
4-Black
Yellow NC
Sadelta the is a BASE mic
1-Shield
2-White
3-Brown
4-Green

Turner
1-Shield & Red
2-White
3-Blue
4-Black
Yellow NC
Road King standard 4 pin wiring Gallaxy/ranger/cobra..............Magnum
I have no info on the 5 pin as i know the OmegaForce version has an addition mic plug, i figure yours might also.

I would suggest shipping the unit in with the mic and let me do it for you. www.dodgem250.com

Here is the wiring information for a Turner RK56. If the picture is too samll for you too see or it does not load up, email me at [email protected] with the subject as RK56 wiring diagram needed, and I will email it to you.

Dean Pitts
Rollin CBs

For a Turner +3 it is 1/shield 2/white 3/black 4/red.For an Astatic 4 wire it's as follows 1/shield 2/white 3/red 4/black ; for a 6 wire it is 1/shield&blue 2/white 3/red 4/black - yellow no connection . Good luck....Dan

pin1 = mic audio,pin 2=receive, pin3= push to talk or transmit, pin5= shield.

cobra usually is white= mic audio, red= ptt, black= receive or speaker complete

From the Astatic wiring guide, here is the information for the DELTA FORCE

WH-1
BK-2
RED-3
SH & BL-5

Rollin CBs
Dean

Same as Omega
#1 Mic Audio
#2 Receive
#3 Transmit
#4 Up/Down for channels
#5 Ground/Shield
#6 13 volt

The Delta Force and Omega Force are wired the same way, so if the mic is not working on the radio, check the mic out to make sure it's working. Make sure you have the mic gain turned up on the radio. I assume the mic was not wired for another style of radio??