My fujitsu siemens desktop will not start up. All that appears on the screen is a no signal message. It is the same if I try and start from the recovery cd. The screen is working as I can use a diffrent PC on it. The Fujitsu has XP home on it

hi you must disable the main screen in properties section of the display panel then when you start up the computer the screen will not activate until windows has loaded and found and installed the screen drivers after that all should be good to go if you need any further help don't hesitate to contact me :)

try going to restore in the control panel restore to a earlyer time and the program will be gone

REMOVE THE USB SENSOR & PLUG IT IN OTHER USB PORT

When your computer first starts up, almost immediately after you push the power button, a prompt on the lower portion of the screen (but not always lower, sometimes upper) will appear saying 'Press F2(for example) to enter BIOS, or SETUP.
You don't have very long to press the button, as the screen will change quickly, but the most common bios entry hotkeys are Del, F2, F10 or F12. Hope this helps.

Does the monitor have two inputs? (Digital - DVI, and Analog - VGA)
If it does, check on your monitor whether the right input is selected; there can be a separate button for input selection, or the selection can be made from the monotor's On Screen Menu.

start your computer in safe mode, from that uninstall graphics driver, than restart tha system.

Check the VGA cable first

try checking your cable connectors, if you are very much sure that there is no loose connections.. then there may have a problem with your video card.

Hi Peter,

Try this solution. Just follow this step to uninstall and reinstall the USB drivers. I am assuming that you have a Windows OS.

1. click START
2. right click My Computer (an icon of this can also be seen on the desktop)
3. left click Manage
4. Computer Management will appear
5. look for Device Manager and click it
6. on the right panel, you will see Universal Serial Bus controllers
7. expand that by click the plus (+) sign next to that
8. delete everything under that by highlighting each one of it, then on the keyboard, just press delete
9. once finish with everything, just reboot the computer

Let me know if this works.

Jon

Did you check if you connected the singal cable properly? If the signal cable drops, you can reconnect it again and see if it works