It won't stop making ice when full - GE Monogram ZDI15C Automatic Icemaker

http://www.aramislashes.com/wholesale-mink-eyelashes/wholesale mink eyelashes WHOLESALE MINK EYELASHES MANUFACTURER-ARAMIS LASHES Our wholesale mink eyelashes is more lighter,softer and more Flexible, our 10 year's experience in wholesale mink eyelashes can bring you more hot fashionable mink lashes, you can get top quality from our lashes factory with fast delivery. Most luxury package wholesale mink eyelashes box is available.
http://www.aramislashes.com/wholesale-mink-eyelashes

Yes the bin thermostat

The eye needs to be re aimed at the target directly across the bin. It has to be clean too.

it may be caused cooling problem.

You will need to replace the "ice control thermistor" on the unit. Here is the part to order. The ice control is number 320 on this diagram.

check bin thermistor connection or replace it is inside the bin on the right side

This is due to the arm that controls the switch on the icemaker itself either being shorted or froozen in the toggled position. Usually the arm would lift as your ice container becomes full and shut the icemaker off until it reached a level where the switch would then toggle to the make ice position and then start makeing ice again. There are three 1/4" screws that hold the icemaker in place remove these screws unplug the icemaker and then use hot water to dethaw your ice maker for about 2-4 minutes after wards dry the icemaker then try reinstalling the icemaker if the problem persists replace the icemaker itself. If you have any further questions message me back I await your reply.
Thank you
Rick

On the flapper that is pushed down by the ice there is a small magnet. It is on the arm on the back right. It trips a magnetic switch. It has either slipped or fallen out completely.

The ice unit is available online. U can disassemble the unit and see if u can spot the problem also. It is not complicated

If you need further help, reach me via phone at https://www.6ya.com/expert/gary_9c859f4aa7e5ab10

you need to clean the eyes on the unit they tell the unt if its full or not,