My viper 5701 2 way remote stopped working. It is fully charged however the "main menu" indicator keeps blinking and I cannot press to lock/start/unlock car at all. I tried to reprogram but holding the function key does not work. CAN SOMEONE HELP ME!!!

SOURCE: viper 5701 remote

read the owners guide look at page 11 remote control programing you have to follow the instructions after your in the programing mode go to page 12 look at the unlock symbol and finish the programing

SOURCE: How do I lock my keypad

there is a way to do it in the manual which can be found at www.viper.com/support.... i did it by mistake and now can't figure out how to turn it off

SOURCE: My Viper 791xv remote isn't receiving the page

My battery ran low and I jump started my car which some how caused the problem. My viper technician made me a buy new remote but the problem continued even with the new remote.
Try disconnecting the battery of your car for ten minutes and then reconnecting it. It worked for me. Now i have a extra remote which i don't need.

SOURCE: My viper 5701 2way remote works, but gives buzz for all functions

hi did you get this unit from ebay? i am going through the same experience right now and there is a problem with the early units that were manufactured. It will need to be replaced. I am currently trying to get a refund.

SOURCE: how to program viper 5701 remote

Unlock doors
Push and hold f button for 8-10 seconds until amber light is on solid
Push Remote start button for about 4 seconds till amber light flashes 3 times
Put key in to IGN position
Push valet (black button) one time and release
Push and hold valet button
Push either lock or unlock on viper remote
Key out of IGN
Test unit
The horn or siren may sound afterwards to indicate SUCCESS!!!!!!