Turns on "no standby light" picture goes off

I would fault find the power supply.

The standby light means the tv is plug into the wall and getting power. A power surge can wipe out a tv and still leave the power light on.

If "Standby light goes off as should" find out what has caused the power supply to fail. Could be a simple as an open fuse

If you removed power by turning off power itself to the set instead of turning it off by turning the set itself off---that is not a good thing to do.

When power is restored a surge can and likely hit the power supply in your set---time for a tech or shop to open it---I suspect they will find the standby or main power supply is damaged or now bad.

It means the set is in shutdown and it based on model listed here has a power supply or related problem.

I see so many here with no sound/nopicture issues:

ISSUES:

1. IF sound main fuse/s are good.
2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.
3. almost all these sets the troubleshooting involves checking voltages on the main power board to narrow down theproblem.
4. Be safe and if you do not know what you are doing don't open the set.

Answers to issues:

1. RE:fuses---if a blown fuse is found get a good replacement(not the genericones like Radio Shack). Many fuses are special even aside from amperage--Don'tput a higher rated amperage fuse in the set for any reason.

2. RE: power supply in set: if total dead aside from main fuse the set uses astandby power supply that runs 7/24 and a main supply (some are combined andsome not.

Here aside from checking fuses you want to examine all the filter caps on thepower/standby to see if any are puffed up or buldged up in some fashion--Iattach a photo of a good one---top should be silver metal and PERFECTLY flatand have no brown material coming out on top or bottom.

What happens in the standby area is they use caps with too low a voltage rating(saves money) which causes them to fail in a year or two---the standby runs7/24 and the heat dries out the caps and they fail.

3. Trouble shooting consists of the above and then at some point you have tobuy and try a board to see if it fixes it or not.

4. Safety first--no TV set is worth getting injured or even killed over.

there is a problem on your power supply section take out the switching power supply from the unit and test whether it operates normally..if it does the problem probably on your high voltage section specially the circuits backlight...replace them.

Have the main power supply checked out first, you only have standby 5v power supply working right now.

1. check power supply
2. check flyback

Ether or you have a ppower fauilure in the unit. and its probably blowing fuses.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Power supply is the place to look, look for bulging on top of the capacitors in the secondary side of the main power supply.