How do I trouble shoot the control panel on a GE Profile Smart Dispense Dishwash

SOURCE: Dishwasher noise

see the fix at the following link:http://www.fixya.com/support/t204050-ge_adorda_dishwasher Simply zip tie the water tube for the middle spray to the upper basket.......it works!

SOURCE: purging ge profile smart dispense dishwasher

How to Purge Incorrect Liquid Detergent from the Bulk Dispenser

The purge routine operates the bulk dispenser pump continuously to drain the bulk dispenser tank when an incorrect liquid was poured in the tank. The process consists of setting up the dishwasher to run the purge mode, running the purge mode and then cleaning up the purged detergent.

Follow these steps carefully to have a successful purge run.

For Top Control Models:

1. Make sure Pre-wash, Added Heat and Heated Dry LEDs are off.
2. Press Heated Dry and Down Arrow buttons together for 3 seconds. All LEDs will illuminate.
3. Press Added Heat and Up Arrow buttons together for 3 seconds. The Anti-bacteria LED will illuminate
4. Press Start button one time
5. Select Normal and make sure Pre-wash, Added Heat and Heated Dry LEDs are off.
6. Press Start button one more time and dishwasher will run a complete cycle without the main motor running. Cycle is complete when the Clean light illuminates. This should take approximately 60 minutes.
7. Open door and wipe up excess detergent from the door and tub
8. Flush remaining detergent off by pouring water on the door and tub where there is detergent residue.
9. Remove SmartDispenser cap and fill tank with water and then replace cap.
10. Repeat Steps 1 through 9 one time.
11. Then, repeat Steps 1 through 6. When the Clean LED illuminates, the system is purged and ready to be refilled with the correct detergent.