How to fix power washer with no pressure with out have to buy the hole pump what can i do to fix it

If equipped on the bottom side of pump.

Dear Audience,

Please go to the link provided and view the on line PDF manual. On pages 16 and 17 you will find the directive to apply detergent into the system and maintaining successfully.

http://www.ppe-pressure-washer-parts.com/files/1961581/uploaded/020292%20man.pdf .

If you are having any difficulty , please check out this direct source Troy bilt Pressure Washer Support ManualsOnline com .

Fare. Well.

Could also be crack/leak in HP pump. If it were left in cold weather without antifreeze, I'd check there first. Part + labor might warrant new washer if more than a couple years old.
Sorry.

OK just so we are on the same page.
You did turn on the water (right?)

Call us when you can be at the washer so we can trouble shoot it with you over the phone.
http://www.ppe-pressure-washer-parts.com/troy-bilt-020416-1-pressure-washer-parts

check govenor

regulator

http://www.ppe-pressure-washer-parts.com/files/1961581/uploaded/020488%20man.pdf
This is for the Briggs and Stratton, basic operations should be the same for the Honda engine.

check the non-return valves in the pump block. if these are damaged or dirty you pressure will be greatly reduced. they are located behind the 3 lage brass hexagonal caps.

I hope this helps

What fluid and how much is required in the Troy-Bilt 2550 power washer pump?