Opening the top cover of cs 1815 - Kyocera Mita KM-1815 All-In-One Laser Printer

The feeder assembly must be out of adjustment this is most likely at the drum. 85 bucks just in parts. Labor would depend on whom you choose to have it repaired with.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Lift the cover up

Hi there just open it up and inside there will be a small plass bottle that hold the waste toner you can clean out and put back.

i don't think it has one...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Check for debirs in the unit that could be tripping the jam sensor if not the sensor has gone bad.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Its very easy let me know wat you want to do or if you want to send you the manual.

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

pull out your drum unit. locate green tab on the right top of unit. now, take out one screw and remove small cover on the rear, right side and empty very carefully.

hth,
razors

This is a fuser problem -- here is a reset method:


First open top cover then turn on power.
press system menu/counter
arrow down to service
press and hold start, # then enter keys
arrow down to maintenance
press enter
arrow down to Sim 163
press enter
select execute
press enter
turn off power then back on

This is a fuser problem. Try this to reset:

First open top cover then turn on power.
press system menu/counter
arrow down to service
press and hold start, # then enter keys
arrow down to maintenance
press enter
arrow down to Sim 163
press enter
select execute
press enter
turn off power then back on

There are two screws on the drum unit. They are on the left hand side and one on the right hand side. Remove the screw from one side and take off plastic small side cover. Dump the waste toner. Do the same for the other side and then put it back together. Turn machine off then on and the error code should be gone......