Model 44072 front load get F3 error code

SOURCE: Kenmore 44072 Front Load Washer Drain Hose Cleaning

Try this link for step-by-step instructions. More than likely you will have to clean the drain pump as well.

http://www.fixya.com/support/r385844-checking_drain_pump_kenmore_elite_front

If you are having trouble draining the water from the wash tub, and cannot get it to drain with a shop vac, you can drain it directly from the tub. If you don't own a shop vac, you may have to bail. If your drain pump does not have a clean out trap, remove the inlet and outlet hoses to access the inside of the drain pump. Inspect the pump impeller for obstructions and/or damage. If the water will not drain when you try to pull a vacuum on the drain line, you may have to disconnect the drain hose from the bottom of the wash tub. In some front loaders, there is a ball valve in the drain hose from the bottom of the wash tub to the drain pump. This ball can act as a collection pint from lint and debris. You will need to remove the hoses from the bottom of the wash tub to clean this area. I would recommend doing this as a LAST resort. Often, it can be difficult to reconnect this hose to the tub and get it to seal correctly. I hope this helps you. Please post back if you need further assistance.

SOURCE: error code f24

F24 indicates a water temperature sensor error. If during the wash cycle in the water-heating step, the water temperature sensor (NTC) value is out of range the F24 error code will display.

Possible causes:

• Too cold of water or hot water is turned off
• Temperature sensor failure or loose connection
• Control board failure

SOURCE: kenmore front load washer #44072 drum banging noise

I have the same problem...the solution is called new washer. I was told it could be overhauled to the tune about $600...barrings are going out. Mine is just 7 years old and that's disappointing.

SOURCE: kenmore front load washer #44072 drum banging noise

2 possible issues with your washer.
1 or both the support shocks or springs have broken
the drum would look off center even when empty
or rear bearring has worn out.
this is a very common problem with the fridgidaire washer... (this kenmore is a frigidaire model)
problem is caused by very hard water (well water) or improper use of detergent. this machine uses a High efficency type detergent, marked by "HE" on the detergent container

Radio Code Pro

• 2200 Answers
• Posted on Aug 27, 2009

SOURCE: my kenmore front load washer keeps showing a F--20

Hi

The F20 error on this machine indicates that there is no or very little water coming into the machine. This means that the pressure switch is not being activated after a while and the error is then thrown up.

See this excellent FixYa link for a complete breakdown of the problem and how to troubleshoot and then solve it.

Acknowledgement jsrock516 for this excellent breakdown of the problem

http://www.fixya.com/support/r1491905-f20_error_code_whirlpool_duet_kenmore

Please do rate my answer. Many Thanks.