How to disassemble a Peavey 1210HS speaker? - Labtec APX 4620 Computer Speakers

Speakers are front loaded onto the baffle - probably. To test the cab - go through the jack panel in rear - probably.

With a screwdriver.
In some, you just pull out the Bass speaker, everything else is sealed, and get at the Xover from the hole....

Dj. NICE!
PeaveySP 6 4 Way Dual 15 Speaker

PEAVEY SPEAKERS

Amazon com Peavey PV215 2 Way Dual 15 Inch Speaker Cabinet Musical...


Peavey com

Contact Peavey toll free at 877-732-8391 or by email at [email protected],

Most Peavey speakers you will have to just remove the grille in front of the speaker. These usually are held by Velcro like fasteners that you must carefully pry the grille out. That will give you access too the screws holding the speaker rim. Be aware that there are different sizes of speaker rims and mountings for the "same" listed size speaker. Also use the same impedance speaker as the original one or you MAY find you have less power OR blow your amp out.

Take the hf driver off, then disassemble the old diaphragm and insert the new one, check the light bulb at crossover network to avoid late issues.

Need to replace the crossovers in a pair of Peavey SP4G Speakers, where can I find the part

there should be Screws on the back of the unit witch takes off the whole back panel to were you see the back of the speaker an the wiring in side the amp, on the speaker mounts should be somebolts or clips to were the speaker will slid out from the back

LIGHT IS PART OF SPEAKER PROTECTION CIRCUIT,CAN BLOW,MINE DID TO PROTECT HIGH FREQ DRIVER