Sony BRAVIA KDL-40S2010 40 in. LCD Television Logo

Related Topics:

A
Anonymous Posted on Jul 12, 2014

My Sony Bravia tries to turn on then clicks off after about five seconds.whats wrong.

The set is almost five years old and when it tries to power up and cuts off it does not show any trouble codes. The only light on the set is the green led that shows power.

5 Related Answers

Anonymous

  • 320 Answers
  • Posted on Oct 18, 2008

SOURCE: green pixel lines

It sounds like a bad LCD panel but you would have to post a picture of the problem for me to be sure

Ad

Anonymous

  • 157 Answers
  • Posted on Oct 07, 2009

SOURCE: sony bravia kdl-52w3000, turn tv on, no picture or

Most likely this is caused by a defective main board. Changing the main board will fix the issue about 95% of the time.

To be absolutely sure, the voltages need to be checked on the power supply. If they are not the values listed in the service manual, then you should replace the power supply instead (accounts for the other 5% of the time).

Anonymous

  • 210 Answers
  • Posted on Oct 09, 2009

SOURCE: My Sony Bravia KDL-26S3000 won't turn on and is stuck in standby.

Hi,

There is a power fault with one of the PCB's inside, contact Sony if you are still in warranty, if not contact a Sony service center as it will need an engineer to open it up to repair it.

Thanks

TdiPWR

  • 194 Answers
  • Posted on Dec 24, 2009

SOURCE: My Sony Bravia Kdl40v300 will not turn on When I

sorry. Hope you still have a waranty. This is not an uncommon problem with the sony's. 99% chance that the panel went out. Could also be a balance board issue, but usually not. Call Sony for an authorized repair center

Chi Chu

  • 8457 Answers
  • Posted on May 06, 2010

SOURCE: My sony bravia keeps switching from

Ur power supply board is dead.Power supply board have dead capacitors like leakages gases,that bulges up it top or puff up it top.U know basic electronic's and soldering,replaced these leakages gases capacitors.Or tries websites like Shopjimmy.com,Ebay,com to buy a refurbish power supply board for the replacement.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have Sony bravia KDL46W950A smart tv it has five time blinking . It is repairable.give me technical support.

Hi Panchal Maheshkumar, I send you the link so you can download the service manual of your Sony Bravia KDL46W950A
I hope you can solve the problem
Greetings Franco Dosil
Hola Panchal Maheshkumar, te envio el link para que puedas descargar el manual de servicio de tu Sony Bravia KDL46W950A
Espero puedas resolver el problema
Saludos Franco Dosil

https://elektrotanya.com/sony_kdl-46w950_kdl-46w954_kdl-46w955_kdl-55w950a_kdl-55w954a_kdl-55w955a_kdl-55w957a_chassis_rb1g.pdf/download.html
0helpful
1answer
1helpful
1answer

Hi we have a 3 year old sony bravia kdl-37v4000, when we switch it on the green light flashes and a clicking noise can be heard coming from inside the set, allso when we turne the set back on from sta

Visit the site named 'Electro-help' for more details. Click this link. View it in "Timeslide" option, which can be selected from the drop down box menu by the [Sidebar] tag, at the top left corner of the display window. It will make search easy. There are more than 1100 posts to different brand TVs now. Pull up older posts there.
1helpful
2answers

Sony Bravia KLV-40S200A LCD TV standby indicator blinks 5 times

Here is a link to the service manual--

http://www.scribd.com/doc/46056922/KLV-23S200A-and-Other

Page 11 explains the error codes--unless you are a tech with a meter etc it will be a shop repair.

A lot of good info including taking set apart correctly.

"abnormal power"

SD TECH
0helpful
1answer

Hi I have a Sony Bravia KLV-40S200A which wont turn on. The standby button flashes five times then pauses for about 4 seconds then flashes again. Any ideas?

I had a similar problem with my 42 Inch Philips 42PLF5432D/37 LCD HD TV. It would turn on but then shut back off after about 10 seconds. Then it wouldn't turn on at all. The problem was a bad capacitor. Several bad capacitors. They are inexpensive and fairly easy to replace if you don't mind digging around in the back of your set and soldering some new ones on your Power Supply Board. Or take the less inexpensive route and look for a whole new Power Supply Board. Good luck. Hope this helps.
1helpful
1answer

Sony Bravia No signal plus flickering image and

You know how to reset the tv to its factory setting, I think you are a technician. Second thing you can do is software update. Go to http://esupport.sony.com/US/perl/swu-list.pl?mdl=KDL42V4100&LOC=3#div_pos_30 . If it doesn’t work. Replace the Main board (UB board). Part # A-1547-086-A Cost approx $320.

Knowledge obtain from: Repair experience on same symptom.
Parts reference: Andrews electronics, 800 289 0300.
1helpful
1answer

Sony bravia on fire!

This type of failure is not common. You indicate that the set is slightly over a year old. As a first step, I would attempt to request a warranty repair from Sony. If the set is close to the 1 year limit, it may be a bit of a fight, but you may get this repaired under warranty. Realize that you will need to speak to a manager, not the initial rep on the phone. Have a copy of your purchase receipt with the purchase date. Now to the probable problem. In all likelyhood, a capacitor has failed in the power supply section. Depending upon its function within the circuit, it is possible that it caused the smoke. Until you have a final resolution with Sony, DO NOT open up the unit. Once you do, any possibility of warranty service is voided. Please update this with any progress you make with Sony and we'll continue from there. Dan
0helpful
1answer

6 flashing lights

Similar problem with my Sony. I unplugged for 36 hours and it seemed to solve the problem.
3helpful
2answers

Flashing Standby Light (6 times every 2 second interval)

A 6 flash error indicates a problem with the backlight. Your set is less than a year old and still in warranty, so you should contact Sony and arrange for a service call to get it repaired.
0helpful
1answer

Sony tv, no pic or sound, lcd blinks

Five blinks - AKB circuit (automatic kine bias), the timer/standby indicator blinks for about 30 seconds then goes to the self-diagnosis function. Something is wrong with the video. Check video out, Q705, 732, 761 and other components on the C board, also check Q218, 219, 220 on the A board. In addition, unit could be in IK blanking, try turning up screen slightly.
Not finding what you are looking for?

276 views

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

matt martin
matt martin

Level 3 Expert

1259 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...