Onkyo tx-ds484 hot to reset to factory defaults

Hi Tkari, it sounds like the receiver would need to be serviced. Thank you, Onkyo USA

press and hold the video 1 button and then press the speaker A button - you should see 'clear' on the display. This will reset everything

It sounds like you also need the manual.

http://www.retrevo.com/support/Onkyo-TX-DS484-Receivers-manual/id/365dj182/t/2/


The remote is an RC-4278. You WILL need it.

$25.10 on eBay expiring tonight so jump on it. 3h 35m 40s (Sep 06, 201120:16:46 PDT)

http://www.ebay.com/itm/ONKYO-RECEIVER-REMOTE-CONTROL-RC-385S-RC-373M-RC-371M-/290597112430?pt=LH_DefaultDomain_0&hash=item43a8f00a6e

As far as the left speaker goes, swap it to decide if it's the speaker, wire or the amp channel. There are no control settings that would make one of the front pair go silent.

I don't have a separate manual for the Onkyo RC-427S. However there are several pages on this remote in the TX-DS484 receiver manual.

See page 30 of the manual here: http://www.intl.onkyo.com/downloads/manuals/pdf/tx-ds484_manual_e.pdf .

I hope this helps.

Cindy Wells

Do you mean ONKYO TX-DS484?

Read the manual which is available for free download after you register at retrevo.com.

http://www.retrevo.com/support/Onkyo-TX-DS484-Receivers-manual/id/365dj182/t/2/

that is always possible if you want to take the time to get directions over the phone

you may want to try a factory reset by pressing and holding vcr1 button while pressing the power button. do this with the unit on. It will reset back to factory default. so any saved setting will be lost and you will have to set again to your settings.

buy an attachment at Radio Shack - Ipod cable to 3 rca cables; plug the rca cables into the
CD input; leave the video cable hanging. It is not a charger, so you will need to re-charge your ipod.

After receiving information and suggested actions from FixYa it was able to determine that most likely, a power outage and surge had caused the speakers need recalibrating. It was a simple task which utilized the remote, now it works fine.

Did you set all your parameters (see manual, page 15)? After that, you can then also change the levels of each speaker (page 16) also.