My program froze while I was creating a design and I can't unfreeze it. If I shut down the computer when I reboot it is still there with the little color curser spinning. I have work to do. Help!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Please try this >Press and hold the 'Power' button and the 'Volume Up' button >Wait for around 5-10 seconds >Your device should then vibrate and reboot (hopefully) rectifying the teething troubles you were having!
Press and hold the power button for fifteen seconds or so, ignoring the "Shut down?" prompt until it shuts off. Release the power button, then press and hold for a second or two until the Kindle starts rebooting.
Reboot it by sliding the power button to off and holding it there. If it still doesnt shut down pull the battery out then hold the power button for 10 seconds. Put battery back in and reboot. Also check to make sure that there are not any updates available for your PSP
There's not much choice here. If your computer is frozen and you can't use the "safely remove hardware" function to disconnect the camera, then you need to turn off the camera, then remove the cord. You will need to do a "hard shutdown" of your computer by pressing the on/off button until the computer shuts down. I wouldn't try the same download procedure again. I would get a separate card reader and use it to download to a folder I create on my desktop. From there, you can import the pics to any program you wish.
I just purchased my T3000 yesterday and it froze after taking a picture. To unfreeze, there is a pinhole at the bottom of the device (on the opposite end of the headphone jacks). Stick a paper clip or pin into the little hole to force a reboot. Hope this helps.
mine does the same thing lg says that it is a automatic reboot function for when it gets confussed or freezes and it is also programmed to shut off when dropped
Check the heat sink..if its not properly insatlled the somputer reaches the warning temp and shuts down the processor to prevent damage..you may have to replace it if its damaged..heatsinks dont cost much..
×