Sc532 error how do we eliminate the error when the yellow cartridge has been changed

If it is pure yellow I would look at the yellow imaging unit (drum) to make sure that it is ok. That is likely the culprit if changing the toner did not resolve the problem.

Are U installed specified yellow cartridge? Chk with old cartridge & chk for the message.. Same error? there is a mechanical issue, carousel unit might be misaligned..To align it technical skills required, better go to the nearest service center.
If different error replace with another cartridge.

this is a fixing unit error. call for change of this unit by and expert thank you

If its yellow cartridge error, replace it, if "resit yellow cartridge" error, >check cartridge contact unit in iss unit,>inter change with another cartridge contacts unit & try for the diagnosis.> replace iss PCB..

00010014 - Ink System Pressurization Error (The Pressure Sensor does not indicate pressure) CClick HERE to view full detail on troubleshooting process.
EXPLANATION:

The error codes in the table below relate to a faulty ink cartridge or detection of the cartridge when installed in the printer. These errors only occur when an ink cartridge is changed. Whilst you may be unable to quickly identify which ink cartridge may be at fault, the steps below provide a process of elimination.

Try to press these bottons one right after the other... The yellow "C" then the numbers 1 >0 >7 then press and hold the "Clear/Stop" botton till the display changes. Then turn the Main power switch OFF then back ON... I Believe the error code deals with the fixxing unit. If it clears, you may have a power problem in your outlet

Yellow cartridge isn't seated correctly. After reseating it and it still gets the error, try swapping the yellow and black cartridge. If the error changes to 10.92.00 then the yellow is bad. if the error stays the same...something is broken, probably the "cartridge lock" for the yellow.

I have had this happen a couple of times to me with a few cartridges so if you can be sure it's just the black that has changed then I'd contact your retailer and request a replacement under warranty.

The only other way to solve this is by process of elimination using some other cartridges. If you know of someone else with a similar printer model that uses the same cartridges then perhaps ask nicely :)

First
------
Remove the "Yellow Cartridge"
Check you have removed all the plastic packaging and tape on it
If you haven't do this and try again

Second
-----------
If you have the old empty cartridge put it back in and see if you get the same error, if you do it eliminates the problem being the yellow cartridge and you have another problem with the printer

Please post back your results or questions and I can help further

remove the cartridge & install the new one cartridge other wise