Question about Indesit W 123 Front Load Washer
CAN I CHANGE THE PCB BOARD ON IWDC6105 INDESIT WASHER DRYER
Posted by Anonymous on
SOURCE: indesit widl126s
Suggestion: Possible your outlet filter is blocked; this needs periodic cleaning, depending on your usage. Clean this out and re-fit. Refer to your users' manual re. where the filter is....
Posted on Jun 16, 2007
My guess without seeing the machine is - The motor has gone / failed.
You could get someone to check the brushes on the motor, it's only a 30 minute job.
If the brushes are ok i.e more then 10mm long, I suspect the motor has burnt out if the machine is a number of years old.
Hope this helps
Posted on Jun 25, 2009
Hello, this usually is signaling that there is a problem in your machine. You will need to get a service technician in to diagnose the problem for you. I hope this is somewhat helpful.
Posted on Nov 04, 2009
It is likely that the pump/filter has blocked thus preventing the water pumping out.
You would need to check and if so unblock it. The location of the pump/filter varies with the brand but sometimes it is behind a flap at the lower front of the machine whilst on others you have to get the back off to locate it.
Posted on Jan 23, 2010
Testimonial: "that worked a treat thanks"
Tips for a great answer:
Dec 15, 2015 | Hotpoint Ariston Aquarius WD420 Front Load...
Dec 23, 2017 | Indesit W 123 Front Load Washer
Nov 04, 2009 | Indesit WA 115 Front Load Washer
Nov 30, 2017 | Indesit W 123 Front Load Washer
Dec 01, 2008 | Indesit W 123 Front Load Washer
Mar 28, 2008 | Indesit W 123 Front Load Washer
Oct 25, 2007 | Indesit W 123 Front Load Washer
91 people viewed this question
Usually answered in minutes!