Why does my Excell XR2625 pressure washer leak from the clear hose?

SOURCE: honda gx270 pressure washer. water is not coming out strong.

did you check the inline screen for dirt?

SOURCE: When garden hose is connected to the pressure

Dear radcongirl,
Try removing the high pressure hose from the machine. Then connect the water hose and see if water comes out of the outlet.( you can also try this by putting on the machine for a few seconds). If water comes out of the outlet, then you have a problem in the high pressure hose or the wand and trigger. Check also the lance and nozzel for blockage.
I do not know what kind or model of machine you have, but most machines the water always comes out of the outlet when water is fed to the inlet. In bigger machines this cannot happen because they have a reserve tank.
Regards,
Fulltech.

SOURCE: Honda excell pressure washer does not have pressure

if the machine is running on suction, ie sucking out of a barrel there may be an air leak on the suction hose or pump. it will pull air easier than pulling water .

put the machine under mains water pressure, hose pipe straight from tap to pump.
check all around the pump and inlet pipes for leaks.
if water leaking this needs rectifiying for it to work on suction.
run the pressure washer while on mains pressure with the hose on, does this make a difference?

if not then probably the unloader is stuck in the pump head. remove unloader , clean and replace it
parts breakdowns are available on the internet for your machine.

possibly valves stuck, or the valve springs have broken, seen this quite few times on these machines. if so replace springs .

These sort of machines do not last very long anyway, about 50 hours use if your lucky.

SOURCE: engine starts up on honda 2500 pressure washer water comes out wand but will not get up to pressure

clean the pressure regulator valve in the pump