What is solution error code in xerox 6204 123-314

SOURCE: xerox 390 error code 1

> Support & Drivers > WorkCentre 390 Laser All-in-One Support > Search Results > How To Clear a Fuser Error Message Solution: Perform a RAM Clear Make Printable Email this page Performing a RAM Clear will restore all of the WorkCentre's settings to the factory defaults. It will also clear all faxes in memory, Speed Dials, One-Touch Buttons, Group Speed Dials, your System ID, and any other stored information.
NOTE: If you are able to print, it is a good idea to print out your Phone Book before performing the RAM Clear, to assist you in reprogramming your Speed Dials and One-Touch Buttons. It is also recommended to print out your System Data List to assist you in reprogramming your system settings. If you are not sure how to print your Phone Book or System Data List, refer to Related Items at the bottom of this page.
To perform a RAM Clear:

1. Press the [Menu] button on the Control Panel.
2. Press the [#] key, then press 1934.
NOTE: These buttons should be pressed quickly. If not successful, try varying the speed you are pressing the buttons.

3. When this step is successful, the bottom right-hand corner of the LCD Display will read 'TECH'.
NOTE: If you are unable to access Tech Mode, please refer to Related Items at the bottom of this page.

4. Press the [Menu] button to start navigating the menu.
5. Press the [Up] or [Down] arrow button until the LCD Display reads 'Memory Clear', then press [Select] button.
6. The LCD Display will read 'US and Canada'.
7. Press the [Start] button to clear memory.

SOURCE: xerox printer error code (04,025.46)

This is a print head position issue.

TRY FIRST (Solutions without parts):
1. Check that the wipe mechanism has homed. 2. Check the printhead position and verify that it has initialized properly / manually home the printhead and power cycle the printers power and check for the error to return. If not then the error was most likely due to non-process function (something out of sequence).
Part likely to be the cause:
GEARBOX AND MOTOR,PROCESS DRIVE - PL 4.0, Item 14.

SOURCE: Fault code

well..it's a system error code..is this an older machine, by chance?

SOURCE: Phaser 8560 error code

Most likely you are using generic ink or ink not made for that specific machine. The black ink is the one causing the problem. the printer will then need to be reset.

Hans De Becker

• 212 Answers
• Posted on Mar 15, 2011

SOURCE: Error code 11,009,46:1444 on Xerox Phaser 8500

the 11,009,46 error in my experience means that, at some point, the printer lost power during an electronic action. in some cases an NVRAM reset will do the trick, but if it doesn't, one of the electric boards has been blown up. XEROX are very protective about which board to replace, so you're quite stuck with their own service in order to have it repaired.