Amana dm70e-e instruction manual - Amana Dehumidifiers

• Indoor Humidity ' Dry Air ' Home Comfort ' Amana (amana-hac.com)

https://www.manualslib.com/manual/542212/Amana-D965e.html?page=5


Amana D965E Use Care Manual Check Bucket Indicator Light Fan Speed...

What model Amana dehumidifier?

need owners manual for amana d950ep dehumidifier 50 pint cap with electronic controls with led service cant figure out what the settings should be

Probably a bad circuit board. Amana is junk..........

hi there.
this is all i could find.
go to this link and it might help you out.
AMANA DEHUMIDIFIER model D945E WILL NOT DRAIN ANY WATER Google Search

Hi,

You could Purchase the Part from :-

http://www.apwagner.ca/index.php?main_page=product_info&products_id=486717&language=en

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Most dehumidifiers have a defrost mode in which the compressor is turned off to give time for the frozen water to melt. The freezing problem ocurrs when the unit is used in very cold weather. Check your manual to see if this unit comes with automatic defrost mode. If it does, it would appear that it is not operating correctly and you can request warranty service. If no defrost mode is available, then your only option is to heat up the room in order to use the dehumidifer within its limit of operation. Some units can operate as low as 36 F, but most units cannot go that low. Find out what your unit's specs are from the manufacturers web site.

We all appear to be in the same mess --Thanx Haier
This product says its Amana, but rest assured it is an Haier
The problem is most likely with the engineering design of the board. Im not an electrical engineer so be careful litning to me to closely :) There is only a half bridge rectifier on this board and 2 zener diodes that clamp down on the voltage. My guess on yours is the Zeners have been shorted and no longer clamping voltage down to aroun 24 volts for the low side of the board. I spoke with Haier and they have no schematics that state the zener specifications. They also said there was a 6 month backorder on ordering a new board. Oh and by the way if you want to order a new board and wait 6 months for the backorder it would cost you 75.00. All this jsut to repeat the problem again, because of bad design. O well ----- I wish products were not made better, so I wouldnt have to fill guilty about putting this in the landfills.