Hp rp5000 replace power supply? - HP rp5000 PC Desktop

Give this a try -

Instructions

1. • 1
     Turn the HP RP5000 computer off. Disconnect the power cord from the electrical outlet.
     
   • 2
     Unplug the monitor, keyboard and any other peripherals from the computer
     
   • 3
     Remove the screws holding the cover in place on the back of the computer. Slide the cover backward and remove it.
     
   • 4
     Lift the green password jumper off of pins 1 and 2. The jumper is labeled "JPWD1."
     
   • 5
     Place the jumper on pin 1 only.
     
   • 6
     Replace the cover. Install the screws that hold it in place. The password is canceled when the computer restarts.
     

not working? or what.. please add details.

You need to open the case and watch the CPU fan. If the fan is not spinning or is spinning slowly it will need to be replaced. Take the computer into your local computer repair shop so they know which processor fan you have for a suitable replacement.

You may notice a large amount of dirt and dust build-up around the heat sink and fan. You can either buy a can of compressed air and give it a blast or take it to your local garage and use an air hose or tyre inflater to blast the dirt and dust from the entire case.

Will it not turn on at all? Or does it turn on and then shut back down?

Your Graphics Card could be going out. You should try replacing it.

If you have the software that came with the printer, go to the next step.
If you do NOT have the software, go to the HP support site & download it.
Then uninstall all software relating to the printer.
Unplug the printer from the power and the usb from the printer to the computer.
Reboot the computer.
Install the software & follow the onscreen instructions.


Rick Jones
www.Desotoisp.com

Hi,

If you just about replaced the guts of the machine then the problem could be the monitor itself. Get another monitor and try that. If it comes on then you know the monitor was at fault.




Regards.

Drivers can be downloaded from the following website

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=339694&prodTypeId=12454&prodSeriesId=339692&swLang=13&taskId=135&swEnvOID=1093#11395

Network driver direct link

ftp://ftp.hp.com/pub/softpaq/sp23501-24000/sp23609.exe

Thankyou

el mejor lugar para encontrar una placa base del ordenador es de eBay.
Las otras compañías van a cobrar dinero en exceso.

Erm, although the slot is labelled AGP1 (HEY HP Accelerated GRAPHICS Port 1 ???), it is not for a graphics card.
It is intended for an enhanced USB card that adds additional USB ports as well as 12volt and 24volt outputs.
The RP5000 was designed to be a POS (point of sale) unit and the additional ports were for devices such as barcode readers, handscanners and card readers to be plugged into.