Repair parts for a base that broke

No the broker foot is still attached to washer.

I imagine it would be unlikely that there would be a fuse in this sort of equipment. I gather the system is dead? It could be anything from a bad connection to a component on the main board that's blown. The only way is to open it up and using a multimeter, check from the plug to the unit to see if the cable has broken and across the switch. (Do this with the unit unplugged of course)

In many cases you can contact the projector manufacturer for replacement parts, The plastic (also known as the chassis) can sometimes be purchased separate. Although a crack should no effect the projectors operation unless it was dropped hard enough to cause a crack.

Is the dock a supported accessory for iPads?

the part is Black and Decker Blender Base Collar Ring BL5000-11
However these are prone to cracking. I ordered a second after my first cracked, and the second one cracked after just a couple uses.

The pedal release can be replaced but the base will need to be checked for cracks as well. if the base is broken most common is the socket the pedal release snaps into. some of the plastic parts have been made with better materials

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_b96ba3f038cf317c

You can order this part Black and Decker Blender Base Collar Ring BL5000-11
I also had the ring crack and ordered another one. It cracked after just a couple uses. So, even though you can get the replacement part, I'd suggest tossing the whole thing in the garbage and buying a different brand.

Consumer Contact: For additional information, contact Aloha Housewares at (800) 295-4448 between 9 a.m. and 4 p.m. CT Monday through Friday, or email the firm at [email protected]

Go to www.sears.com, click on parts, the part you need is:
BASE-NOZLE 8191779 (4370725) 11650812007 $ 33.09 $ 33.09
You can order it thru sears online. Cost is $33.09, plus tax and shipping.