WHAT DOES ERROR 102 ON AN OKI 8480 MEAN? - OKI MICROLINE 8810 Matrix Printer

Error code 122 means " Low voltage FAN error ".

Is the FAN (bottom right of the front) of the low voltage power supply block working? Is the FAN connector connected correctly?

Check to make sure connection of the FAN connector. Replace the low voltage power supply unit. Replace the FAN motor. Replace the low voltage power supply unit.

Source: https://www.okoki.co.uk/how-to-fix-oki-printer-error-codes

it means FUSER MOTOR LOCK ERROR call a tech or you could try replacing the fuser motor

A lot depends on what device you are using the Chrome browser on. If you are using a Windows device (not iPAD) then there maybe some installation problem with Chrome. Follow the instructions on this webpage.

Errors 102 and 103

231 means RFID reader I/F error. 03 means Communication error
between the RFID reader and the tag chip. The remedial measure is to check for normal connection of the antenna cable.

Service call 172:Error & 173:Error

Both errors mean -

Abnormal temperature detected by fuser thermistor (high-temp or low temp.)

Does error reoccur?
YES -

Turn power ON again. Replace fuser unit.

If you are referring to a POST error.. one that appears when you first turn on your PC
Error 102 indicates a system board timer failure
You can try turning it off let it sit for 5 minutes then back on again... if it comes back you need a new system/motherboard

i got that error on the first day i got my oki c5950 it was a result of a paper jam in the fuser unit, i removed the jamed paper but the error was still there, i contacted oki support and got a detailed explanation on how to fix this error with a patch file, so if u or anyone out there r still having that problem send me a mail on [email protected] and i will forward u the info.
good luck

The error means that the media is wrapped around the heat roller of the fuser. The only way to reset this error is to replace the fuser unit.

A fatal error 917 means there is a problem regarding the belt **** sensor.

Usually it means the printer can't see the transfer belt rotating.

First thing to try is to remove and re install the transfer belt, if that does not work you should replace the transfer belt.

Error 020 is a ROM dimm error, could be as simple as reseating/replacing Rom Dimm or a expensive main PCB, you need to get hold of a oki dealer, contact oki to find closest OKI repair agent.
www.oki.com