Question about MSI Computers & Internet

1 Answer

Where do you plug in the little internal speaker for your beeps on an MSI Z87-GD65 mobo?

I need to hear the beeps because I just built this pc today and it only powers up for one second and shuts off. All fans start spinning and LED lights on front of case come on but then it just shuts off. Have not even been able to install Windows 8.1 yet.

Posted by Joseph D Thomas on

Ad

1 Answer

Floyd J Stalinski III

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

  • MSI Expert
  • 89 Answers

You plug the internal speaker to the JFP2 connector:
where do you plug in the little internal speaker f - plug-in-little-internal-speaker-beeps-l5kwqkgrhcxrvei1oqtkoiub-4-0.jpg
Support For Z87 GD65 GAMING

Posted on Jan 13, 2015

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: unpluging 4 pin power on mobo Pc starts but no video,keyboard etc

how do i fix the monter I tryed to put the power and rest on and motherboared comes on not the monter

Posted on Mar 14, 2009

Ad

Anonymous

  • 2351 Answers

SOURCE: 915PL-A2: no post, no beep, no keyboard lights

You may have a short between the board & the case. (check it).
Even if this means removing the board. That clicking you hear through the speakers suggest a short. Make sure your using (Stand offs) which keeps your board off the case's mounting surface. Check the back plate so the tabs are touching the ports comming off the board for good ground.
Double check the you have fully connected both the main power ATX_ 20 pin power connector & the auxiliary 4-pin power
connector. pg. 10. Connecting 20/24-pin power cable Remove & re-seat. If your PSU has a 20 pin connector make sure you connect the cable from the correct end.
Without POST you will not get video to load. Reset your bios
pg. 9 in your manual. Re-enter your bios and setup the bios settings for your board.

Let me know if this helps you reach POST?
Good luck!

Posted on Mar 14, 2008

Anonymous

  • 440 Answers

SOURCE: Black screen and beeping.

try to use pci card to getto screen agp ect ok maby bios thinks its that output reset it pull out battery then back in

Posted on Feb 03, 2008

Anonymous

  • 81 Answers

SOURCE: No beep,No Display on my monitor,only CPU heatsink fan is moving

You motherboard has onboard video. It's possible it needs to be disabled and the option changed to use the pci or pci-express slot for the Ati card you installed. Since you have no post error beeps this is the best place to start. Also I had built a system not to long ago and had a similar problem. Resetting the cmos on the motherboard (usually a pin combo) solved the issue.

Start by hooking up your vga cable to the onboard video.

Hope this helps.

Posted on Apr 07, 2009

Anonymous

  • 2 Answers

SOURCE: pc can't boot up , no display , hdd led is constatly lighted

Check CMOS battery(Coin shaped battery), it should show 2.5-3V, if not then replace and check, you can even try and test the mbd without the CMOS battery. Some mbd does not boot with a faulty CMOS battery.

Posted on Jul 03, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

A new pc i just built will only power on for one second and the shuts off. Here's my specs: I5-4670 K ,. MSI Z87-GD65 , 8gb Kingston Hyper X Fury , Gigabyte GTX 770 OC 2Mb, Evga 750 G2 PSU.. All fans


Now remember, the G2 main board cable has 2 connections on one end, and one on the other. You have to make sure both are connected. This is a common issue.
24705309-bsgsyvatoo5tbjj50gcrqdfu-4-0.jpg24705309-bsgsyvatoo5tbjj50gcrqdfu-4-2.jpg
If this doesn't work, check to make sure that all your cards are properly seated.

EVGA Products EVGA SuperNOVA 750 G2 Power Supply 220 G2 0750 XR

Jun 26, 2014 | MSI Computers & Internet

1 Answer

Anyone here having any problems with the reliability or durability of MSI motherboards?


I have only purchased one and that PC build is still running at a friend's house (11 years). I suggest that you go the following URL (Newegg) and peruse the reviews of recent consumer experience:

Home Computer Hardware Motherboards Search Results

May 23, 2014 | MSI Computers & Internet

1 Answer

What is your opinion on the QC and reliability of MSI mobo'


GO WITH THE MOBO YOU READ THE BEST REVIEW ABOUT.

May 23, 2014 | MSI Computers & Internet

1 Answer

Need wiring intructions for msI-990fxa-gd65-v2


Hi,

The closes one I could find is the MSI 99FXA-GD65 (Link Here) Is this the one.

Apr 17, 2013 | Micro-Star MSI 990FXA-GD65V2 Desktop...

1 Answer

HP Pavilion Media Center m8200n upon turning on it only beeps, and led light blinks twice contiuously, with no signal to monitor?


Power On LED Carl?

I ask that because most Power Supply's that HP uses, have an LED on the back also.
(HiPro, Delta, and Bestec)

The LED is now working as a diagnostic LED.
(Light Emitting Diode, so stating LED light, is redundant)

The beeps you hear are BIOS Beep Codes.
The computer's way of telling you something is wrong, and an area to look into for it.

As stated, it's a Code.
One example;
3 Short beeps,...pause, 3 Short beeps,...pause, etc.

With the Power On LED blinking 2 times, then a pause; indicates,

A) Computer is dirty inside. To include Power Supply

Computer is unplugged from power, Anti-Static Procedures are FOLLOWED; and a can or two of compressed air for computers, is used to clean it out.

I have a procedure to follow if you are interested.

B) Processor (CPU) fan is not seated correctly, and/or is Not functioning, or functioning properly.

Case open, and computer on; see if the Processor fan is;
1) Spinning

2) Looks to be spinning the proper speed.

No, I don't expect you to count the Revolutions per Minute, lol!
My reference is a general one. If the Processor fan looks to be turning slowly, you'll know it

3) Processor fan spins intermittently. Spin, slow down, stop....spin, etc.

C) Thermal Paste in-between Processor, and the finned Heatsink that sits on it, has dried up.
Lost it's thermal conductivity properties.

Top of Processor, and Bottom of Heatsink; MUST be THOROUGHLY cleaned, and fresh, new Thermal Paste applied.

I have a procedure for this too.

I can guide you step by step.

Post back in a Comment.

Regards,
joecoolvette

http://h10025.www1.hp.com/ewfrf/wc/product?cc=us&lc=en&dlc=en&product=3548185

How to > Adding/Replacing Hardware > Opening the PC Case,

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00583783&tmp_task=useCategory&cc=us&dlc=en&lc=en&product=3548185

http://www.hardwaresecrets.com/article/274

http://www.tigerdirect.com/applications/SearchTools/item-details.asp?EdpNo=3071621&CatId=503

Apr 03, 2013 | Computers & Internet

1 Answer

Fan just work for seconds


Replace the fan or your computer will run hot and keep turning off.

Or are you saying this is what happens when you power on the computer? if so: When you press the power button do you hear fansrunning, hard drive spinning, lights on the computer, hear any beeps or lightsconstantly blinking, hear the DvD/CD drive click and the light on the drawer ofthe DvD/CD turn on for a second or two? If so the laptop is trying toboot or may have booted, but the screen is not showing for some reason.

Beep tones and blinking lights tells the technicians what is going on with thelaptop and why it is not booting. Most times it's a motherboard issuewhen you hear beeps or blinking lights continuous.

Mar 28, 2012 | Computers & Internet

1 Answer

What causes red led on starting?


Remove Power Cord then press and hold the power button for 30 seconds, then put the cord back in and try to start it.

When you press the Power Button are you hearing the fans run, the disk drive running, the cd drive click and the light on it comes on for a second or two?

Anything shows up on the LCD Screen?

If you press the power button and absolutely nothing is happening then you most likely have a bad power supply.

If you press the power button and you start hearing beep sounds or blinking lights in a continuous pattern (ex. 1 long followed by 2 short) then you have a motherboard issue. Those beep sounds and blinking lights tells the technician what is going on with the computer.

Mar 23, 2012 | Dell Dimension 4600 PC Desktop

1 Answer

Can't find connectors for internal speaker on MSI Motherboard K9A6M3


It should be something like this, look at the bottom edge.
.


2_22_2012_2_28_32_pm.jpg

Feb 21, 2012 | MSI Computers & Internet

1 Answer

P5KPL-AM speaker beep


Hello, I am the technician that will be assisting you today. My name is Norman-Wynne Damstra.

Welcome to Fixya, Sadael.

Yes some-times the case/computer chassis does not have an internal BIOS/CMOS beep code speaker built in.

So what you will need to do is go to your local computer store and purchase a mainboard beep code speaker. You may even find it online at your favorite computer store.

The modern speaker is very small compared to the older mainboard beep code speakers.

Your computer will continue to work without the speaker, the beep code speaker is there to help diagnose/troubleshoot problems when they occur.

Take care!
Norman-Wynne Damstra

Dec 16, 2011 | ASUS P5KPL-AM SE Motherboard

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

443 people viewed this question

Ask a Question

Usually answered in minutes!

Top MSI Computers & Internet Experts

Lee Hodgson
Lee Hodgson

Level 3 Expert

4810 Answers

Davit Mamyan
Davit Mamyan

Level 3 Expert

552 Answers

Roy May

Level 3 Expert

435 Answers

Are you a MSI Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...