How to replace a kill switch on a husky 288 xp

Push off electrical connector and then there is a philips screw going down into the housing, unscrew that and then squeeze the two side tabs of the switch (left and right inside the cover) and it should pop out. Replace the switch and don't forget to put the screw in as it is the other side of the circuit and if you do not replace it, the saw will not stop.

take spark plug out hold it a millimeter away from head and it should spark or if you like getting shocked then hold the spark plug between your fingers i would not do that because it can kill you

Gently turn the needle valves in till they stop. Then turn each one full turn out.

The fuel tank vent is built into the body of the saw. There is a plug cover of the fuel tank vent valve adjustment shaft just in front of the saws handle on the right chain drive side of the saw. Seek a professional.

Mag. failure on husky`s is quite common, l had a similar problem with my husky chainsaw.l would on your`s try another spark plug first then check the mag....

Have you used a geunine OEM cylinder and piston. Cheeper aftermarket parts are a waste of money.

your wires to the kill switch are most likly cut also need to re wire all that was cut with wiring diagram

You can get the part from husky website at:

http://www.huskysupport.com/products/product.aspx?ID=4

From there scroll down till you see part number
6102018
switch Knob for $5.38

Hope this is what you are looking for

I need to replace the ball bearings in my Husky THD950L tile saw. Please tell me where I can find them.

you are wanting a wiring harness

your best bet aside from ordering one is to buy a service manual from www.ferracci.com or local husqvarna dealer and use the wiring schematic to build your own race harness........don't forget the kill switch.