How do i insert the paper in my canon ps3-dh v?

Could not find anything directly about a Canon P26-DH III calculator but, here are steps I found for a similar model. Please let us know if this does the trick for your situation or not. Thanks & Good Luck.!

Installing a Replacement Roll
---
Move the power switch in the upper right corner of the calculator to the "Off" position. (or wherever it may be on your model)
---
Push the wire roll holder back so it protrudes from the back of the calculator. Place the replacement roll on the holder so the paper's end extends from the bottom of the roll.
---
Cut the paper's end diagonally and insert it into the slot in the back of the calculator.
Step
---
Move the power switch to the "PRT" position to turn on the calculator.

hi. the is a little slot located in the back side of the machine insert the tip of the paper there and press the upper arrow in the keyboard. .

Install paper roll with end coming up from rear. Insert end of paper into slot at back of calculator until it stops. Then press feed button until paper advance thru slop at top.

For loading paper into canon p23-dh v is to cut a piece of index card to the length of 3 inches and to the width of the paper you want to load. Tape evenly to the end of the paper roll and put into the ****, pushing gently in and at the same time pressing the 'Feed" button. It will immediately feed since it is firmer than the Poat-it paper.

Rather than try to describe the process in words ("lift up the arm, then feed the paper through..."), I'll point you at the illustrated instructions in the manual at the manufacturer's web site: http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=DownloadDetailTabAct&fcategoryid=349&modelid=9785

looked over P1-DHV Calculator found slot on top back middle of machine where paper goes in easy then up into machine with paper feed

The calculator wouldn't take the paper but when he cut the corners off the paper to make a blunt "V", it grabbed the paper right away and pulled it through.

Put paper roll on paper arm with the end of the paper coming down from behind. Cut paper on a diagonal. Insert the paper into the **** at the back of the calculator. You need to really look to see it. Use the feed button to feed the paper through..

Canon website says For your convenience, a copy of the manual for the P170-DH is now available on the Drivers & Downloads tab on the consumer site. http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=253&modelid=9785#ModelDetailAct

Okay just figured this one out but on the back of the claculator there is a slip slid paper in that Press the feed key and allow the paper to feed through the claculator if it doesn't feed through push the paper in a little and hit the feed key again. It worked for me