Question about Fisher and Paykel Fisher & Paykel Washer

Open Question

My fisher and Paykel will not spin

It does every thing else , but will not spin

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 146 Answers

SOURCE: Fisher & Paykel GWL10 US won't spin

If the machine still has water in it, the drain pump is jammed or there may be an obstrution in one of the hoses. It is most likely the drain pump. Switch off the machine at the wall and unplug it. Tilt machine against a wall and look underneath. On the right you will see the drain pump. It looks upside down. Unplug the wiring harness to the pump and remove pump by turning it clockwise while at the same time releasing the little white clip that holds the pump in place. Clean thoroughly and replace pump.

Posted on Nov 03, 2007

Ad

Anonymous

  • 146 Answers

SOURCE: fisher paykel washer

The drain pump is jammed. Switch off and remove the plug from the wall socket. Tilt the machine back so you can look under it. On the right you will see a motor which looks like it is upside down. This is your drain pump. Remove the wiring harness from the pump and turn the pump clockwise while pulling back the little white plastic clip which holds the pump in place. Clean thoroughly and replace pump.

Posted on Nov 03, 2007

Ad

Anonymous

  • 92 Answers

SOURCE: IW712- fisher paykel intuitive eco.

I BELIEVE THAT IS A ROTOR SENSOR ERROR
REPLACE THE ROTOR SENSOR

Posted on Feb 22, 2008

Anonymous

  • 145 Answers

SOURCE: Fisher Paykel washing machine model # GWL15 drips

Hi Dale..
It sounds like you have a leaky inlet valve assembly. The part number is 421029P and is easy to replace. You can get one here:
http://www.fisherpaykelparts.net/ecart/item.php?item_id=266&category_id=56

Posted on Apr 20, 2009

Anonymous

  • 10 Answers

SOURCE: Fisher & Paykel GW612 Top Loading Washing

Hi there
That fault is the pump blocked error (no change in water level).
i have a quick and easy way to solve this problem.

first turn the machine off then tilt the machine back and lean it on something(a chair or wall), look underneath, in the top right hand corner of the plastic outer boul you will see a small pump motor it has a fan on it spin this fan and if it is hard to turn that means there is somthing stuck in the drain pump keep turning the fan and try to free whatever is stuck in the pump, then try the machine on spin again all goin well the object in the pump should come out with the drain water(doing this will not harm the machine) if the object is still stuck you will need to get the water out of the machine (bailing or siphioning will work) and tilt the machine back again and take the wires off the pump and there should be a white tab on the boul holding the pump on pull this tab and twist the pump anticlockwise about a quarter turn(you will need a few towels or a boul or bucket to catch the water) and it should come off exposing the blockage.
Hope this solves your Problem.

Nick

Posted on Aug 03, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Model gw 712. Why are lights 3, 5, 7, and 8 flashing?


Hotpoint, GE, RCA Washer Repair - Does not spin or drain ...

? 6:13
https://www.youtube.com/watch?v=69az-ZA3eSQ
Jul 10, 2013 - Uploaded by ApplianceVideo.com
Hotpoint, GE, RCA Washer Repair - Does not spin or drain - VWSR4150DAWW ... Fisher & Paykel ... my washer won't drainnor spin. what is the problem? .... But in the end, this video helped me fix our washing machine.

How to repair a Fisher Paykel Washing Machine

www.instructables.com/.../How-to-repair-a-Fisher-Paykel-W...

InstructablesHow do I remove the lid on a F&P intuitive eco washing machine to get to the motor panel?? IMadeIt ... It runs until the spin cycle and it drains but won't spin.

Dec 18, 2015 | Fisher and Paykel Washing Machines

1 Answer

It was on the last cycle spin it stopped had pumped the water out but stopped spinning.


Expert Tips, Troubleshooting & FAQs - Fisher & Paykel ...

https://www.fisherpaykel.com/us/support/expert-tips/Fisher & PaykelFind Tips, Troubleshooting Information, How-tos, FAQs and Answers to Commonly Asked Questions about Fisher & Paykel Appliances.
also on Youtube

Aug 17, 2015 | Fisher and Paykel Washing Machines

2 Answers

My Model GW712 won't spin or drain Top loader fisher & paykel


hi there the first thing ill tell you is that the washer needs to drain water before it can spin there are only a few factors that prohibit this operation a faulty lid switch secound a blown or blocked water pump being a fisher paykel they are famous for jammed water pumps as they decided when they built the sysyem to turn the water pump upside down this causes a lot of stress on the water pump see if you can lay the hose on the ground and get all the water out i belive the machine will then start to spin dry. in this case it is the water pump and have it replaced its a simple operation if you can order the part fromf/p you simply turn the washer on its side depress the white latch next to the pump turn the pump clockwise till ity release from machine disconnect power supply plug and fit new unit as per reverse


best of luck

sonic boom electronics australia

Nov 06, 2010 | Fisher and Paykel Fisher & Paykel Washer

1 Answer

My fisher and paykel smart drive starts & fills but as soon as it trys to wash, the tub slightly goes round then it starts error beeping. I tried to spin it, it will rinse but not spin does the same...


just below the wash tub there is a very sensitive sensoer over time it builds up with dust and at the ends youl find slite corrosion clean the sensoer and it will be fine also clean any rust of the capstan rim for more detailed instructions feel free to email my company [email protected]

Apr 21, 2010 | Fisher and Paykel Fisher & Paykel Washer

3 Answers

Have a Fisher abd Paykel smartdrive excellance 7.5 all the lights workwill fill wiht water but will not spin by openeing ancl closing the lid you get 1/2 sec try to spin then nothing all you hear is a low...


fisher and paykel 6.5 excellence kelvinator washing machine,lights up,no water,checked hoses to the tap .water comes to the machine ,fill plastic reserve. no water goes in the tumbler.,? .any suggestions.thanks

Aug 15, 2009 | Fisher and Paykel IWL12 Top Load Washer

1 Answer

Fisher and Paykel GW708F Screaming like a jet engine on spin!


Hi there

Yea if the machine sounds like a train going through the middle of your house when its on spin it will most definately by your seals and bearings, an easy way to check is lean the machine back onto something and look underneath if the main seal is leaking and the bearings are run there will be rusty looking residue on the motor rotor(the round thing in the middle of the drum), seals and bearings are fairly expensive to replace About $350NZD if no shaft is needed and up to $500NZD if a replacement shaft is needed.

I hope this helps you out.

Nick

Aug 03, 2009 | Fisher and Paykel Fisher & Paykel Washer

1 Answer

Washing Macine


You have a blocked pump, tilt machine back and take pump of, it is the small thing with the black fan it is 3\4 turn to get it off, remove the blockage and you should be all good :)

Sep 13, 2008 | Fisher and Paykel GWL11 Top Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3053 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

peter gittos
peter gittos

Level 2 Expert

247 Answers

Are you a Fisher and Paykel Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...