Talon at3351 Close choke, start. Open choke rev it then it just stops. Starts again pretty easy.

Possibly helpful youtube video.

https://www.youtube.com/watch?v=mXVYXWndPiA


Talon Line Trimmer Coil Replacement

Hardware Store, or local mower repair shop.

Start with the choke on full press the fuel siphon button till the lines are full of fuel. pull handle until it tries to start but stops. move the choke to half then start again. let it run for 60 seconds on full. don't move the choke to full or it will stop. Either slow the revs and then put the choke on full or keep the revs high and slowly move the choke to full (to allow the governor to slowly advance with the new revs)

It's not in either the manual nor available parts list. Contact Talon.

Tel: +27 (0)11 828 5085
Email: [email protected]

It sounds like either the jets in the carb are plugged or the slide diaphragm in the carb has a hole in it. First take the air filter cover and air filter off the carb. Start the engine with the "choke". Do not get your face too close to the carb but look into the carb and gently rev the engine. The slide should move up and down. If so, the diaphragm is probably alright. If the bike has been sitting up for a good while, the gasoline in the float bowl would have evaporated and left behind a thick gummy residue. This may have the main and slow speed jets plugged up. The carb will have to be taken off the engine and professionally cleaned.

Good Luck
Steve

First place I'd check is the carbs - make sure the choke isn't engaged!
Choke on = easy start + easy idle + easy revs + bog under load.

Too much air (hole in the airbox, hose off the airbox) can do this too.

If still under warranty have it serviced (authorized dealer not Joe's lawn mower). There should not be a fee (paid by Husqvarna). There have been carburetor problems. If you adjust it your warranty will likely be void; Joe's small engine service just as likely to void any warranty. Are you using a fresh 40:1 fuel oil mix. The will not start with choke set is normal. Start procedure in your OM says listen for sputter and disengage choke. Almost all new saws have similar start procedure.
Start Procedure
Cold:

1. Ignition on/off to on.
2. Set compression release – optional step even if saw is equipped with a compression release.
3. Pull (close) choke, set fast idle (done when choke closed on some saws); pull starter and listen for an attempt to start. once heard (usually two pulls; no more than 4).
4. Set compression release – optional step even if saw is equipped with a compression release.
5. Push (open) choke pull starter until it starts. (usually first pull).

Warm:

1. Ignition on/off to on.
2. Set compression release – optional step even if saw is equipped with a compression release.
3. Pull (close) choke, set fast idle (done when choke closed on some saws) – Do not pull with choke closed.
4. Push (open) choke, pull starter until it starts. (usually first pull).

If you have more questions or need additional help please reply below and I will get back to you. HTH & Good Luck.
Lou
Thank You for using FixYa.

i have a talon lawnmover starts get but revs are low ,i move choke up and down doesnt change revs anymore

hey pete
This is easy, prime bulb 5 to 7 times with choke lever full out. Pull string, once engine starts turn off choke and pull string again. ( throughout process do not pull trigger )Engine should start, let it idle 30 seconds, then finally pull trigger to rev up engine.

It depends on the tempature, if its pretty chilly out yeah. Try easing the choke in slowly, and when it will idle at about half choke go aheand and take off but run the bike easy for a few minutes then close the choke.