Intermittent power in 33600 coffee maker - West Bend 33600 Coffee Maker

According to West Bend, not cleaning it, especially the heating unit well, will cause this. Here's the link for your manual. Go to page 3. This manual covers 3 models, including #33600. http://www.manualslib.com/manual/189911/West-Bend-13500.html#manual

often happens when using the Westbend and other appliance on the same circuit. Once the coffee is perked heat maintenance is no problem for the circuit, but two heavy users on the same circuit, i.e., coffee maker and microwave or coffee maker and roaster oven is asking too much

The West Bend Large Capacity Coffemakers do not use replacement filters. The manual for the West Bend 33600 Large Coffee Urn is available here:

http://www.westbend.com/supportdata/L5613B_LargeCapacityUrns-All.pdf

Use an electric perk or regular grind coffee in the percolator basket rather than a 'drip' or finely ground coffee that would require a filter.

If you require a new basket, please see the West Bend on-line replacement part site here:

http://www.westbend.com/catalog.cfm?dest=itempg&itemid=946&secid=87&linkon=subcategory&linkid=125

The Instruction Manual for your coffee maker can be found here:

http://www.westbend.com/supportdata/L5613B_LargeCapacityUrns-All.pdf


100-CUP MODEL #33600

Water Level Measure of Ground Coffee

100 cups 6 ¼ cups

80 cups 5 cups

60 cups 4 cups

40 cups 2½ cups

Do not make less than 40 or more than 100 cups of coffee at one time. Use electric perk or regular grind coffee; a filter liner is not necessary.

There is an o-ring that is in there to seal keep the seal between the spout and the level. However, that seal is not available as an individual piece from West Bend. The spout and level come complete as one unit.

You can download the manual for your West Bend coffee maker from this page:
http://www.focuselectrics.com/catalog.cfm?dest=itempg&itemid=30&secid=54&linkon=category&linkid=62

contact west bend customer service 866-290-1851

Im sure one of the thermostats is a high heat thermostat but more than likely the element is covered with lime, I would put some diluted "Lime Away" and let it soak for a few hours then drain it and run clear water through it three of four times.

If this doesn't work for you then I would change the high heat thermostat.

Yes, if you have no continuity across a thermal cut-off, that means it is blown.

hello!
try this!
http://www.abtecparts.com/westbend.htm
Try this to order all of your part needs
eric