How do I replace a broken bose link cable ?

To connect an SA-2 amplifier to a BOSE 321 Series II Media Center, you will need to use a 3.5 mm audio cable. Connect one end of the cable to the headphone jack on the SA-2 amplifier and the other end to the auxiliary port on the BOSE 321 Series II Media Center. Once connected, you will be able to enjoy amplified sound from your media center.

<a href="https://suburban-news.org/">Slot Online</a>

Check with Bose webpage.

You can consult (and then order one) on replacement parts catalog.

Hi Susan

As there are no user serviceable parts inside your unit, your best bet would be to contact Bose directly. This is likely best left to the pros, especially if the unit is still under warranty.
Here's the link to your owners manual, service centres are on page 29.

Good luck!
-Steve


https://www.bose.co.uk/GB/en/images/owners-guide_Wave-Radio-CD_AM250723_05_tcm6-57006.pdf

hi,
You need a STEREO to RCA cable for connecting you I pod to the audio input of you boss. you Can connect the stereo jack in the one end of the cable to the I pod and the RCA end to the boss's audio input L/R.
i have added the picture of the cable for you reference.
ok

Unless you have jerked it or pulled it hard this cord does not malfunction normally.Please inspect the jacks at both the end carefully in good light, and see if the pins are all straight and not bent by chance. If you want a replacement you will have to get it from a Bose store since it is a dedicated cable.
Or else if you want to test it yourself use a continuity tester ( or multimeter in Ohms range ) and touch it pin to pin on each end and see if the continuity on any one pin is broken.

get a 3.5mm male to 3.5mm male cable(one end to the laptop headphone jack and the other end to the AUX jack of the Bose wave music system), you are good to go...

Stations and time are set with the remote as per your user manual.

I have had a few of these come to my shop. The gears jump out of timing causing the cd lift to jam or become unalligned. The unit will have to be disassembled to get the CD out and the unit itself will need to be serviced (rebuild and retime cd changing mechanism)